VEMCO – VR100 Receiver Operating Manual – Page 37
4.3.1.2.3 Configure a Channel for Continuous Sensor transmitters
(1 or 2 sensors):
From the Main screen:
1.
Select Config (right selection button).
2.
Press “1” on the keypad.
3.
Highlight the desired channel number on the keypad by using either the arrow buttons or the numeric
keypad.
4.
Press the right selection button to select “Configure”. The channel’s configuration is displayed in a
summary screen.
5.
Select “Edit” with the left selection button. Use the up and down arrows to cycle through the four tag
types until “Cont 1 Sensor” or “Cont 2 Sensor” is displayed, depending on the tag type, and then select
“Next”.
6.
Select the serial number of the tag by either using the arrows to move through the list of tags setup in
the receiver, or by entering the serial number on the keypad and then select “Next”. If the serial
number isn’t setup in the receiver, an “ERR” message appears and the serial number must be entered
(see section 4.3.4.2 and 4.3.4.3).
7.
Review the settings in the summary screen.
8.
Select “Accept” to accept the configuration and return to the “Configure Channel” screen.
After the configuration settings have been entered, the summary screen displays the settings. The
configuration isn’t saved in the receiver until the “Accept” in the bottom right corner is selected (press the
right selection button). If the changes aren’t acceptable, then use the “Edit” option to repeat the
configuring process or the Menu button to leave the configuration of the channel without saving the
changes.
4.3.1.3 View Channel Configuration
The channel configuration can be either viewed or edited. How to edit the configuration is explained in
section 4.3.1.2. How to view the configuration is described in the steps below.
From the Main screen:
1.
Select Config (right selection button).
2.
Press “1” on the keypad.
3.
Select the desired channel number on the keypad and press the right selection button for “Configure”.
The channel’s configuration is displayed in a summary screen.
4.
Select “Accept” (right selection button) to return to the Channel window without making changes to
the channel’s configuration.
