Vemco HR2, Руководство пользователя

Страница: 26 / 212

2.2 HR2 Dummy Plug and Locking Collar
The
Dummy Plug
is used to protect the external connector
from moisture and damage while it is not connected to the
cable. The dummy plug is held in place on the HR2 with a
threaded
Locking Collar .
The HR2 is shipped with the locking collar attached to the
external connector to give the pins additional protection
during shipping. When the HR2 is stored, the dummy plug
and locking collar should be in place and will need to be
removed before communicating with Fathom. The dummy
plug should be returned to the external connector when a
cable is not connected to the receiver.
Removing/installing the Dummy Plug and Locking Collar
Follow the instructions below to remove, and reverse the steps to re-install.
Step 1 - Twist and unscrew the Locking Collar
Twist the Locking Collar (see arrow) counter-clockwise until it separates
from the receiver. Slide it away from the connector.
(Dummy Plug on VR2C receiver example shown)
Step 2 - Gently pull connector off
Grasp the dummy plug at the connector and pull straight back to remove it
from the HR2 case. Grip the connector rather than the ball end of the dummy
plug to reduce the chance of damage occurring to the plug.
(Dummy Plug on VR2C receiver example shown)
17
2.2 HR2 Dummy Plug and Locking Collar