Vemco HR2, Руководство пользователя

Страница: 174 / 212

8.2 Status Light Flashes
The
Light Emitting Diode (LED) Status Light
on the side of the HR2 case flashes based on the task
being performed or the status of the receiver. The flashes can be interpreted using the table below.
HR2 LED Flashes (during normal
operation)
Meaning of Flashes
No flash Battery is disconnected or has depleted, or receiver is in
Suspend Mode
2 quick red flashes every 5 seconds HR2 is in Record mode (records any received pings)
2 quick red flashes every 10 seconds The HR2 memory is full
One short red flash An acoustic ping was received
One long red flash A PPM detection was written to memory
One short blue flash An HR detection was written to memory
One short green flash* An acoustic ping was transmitted
One long green flash* Transmitted pings were written to memory
* Green flashes only occur if the transmit feature is enabled. For more information on enabling or
disabling the transmitter, see
"HR2 Transmitter Tab", on page 44 .
The Status Light (LED) on an HR2 flashes either red , green or blue . Generally, the red flashes are
related to received pings, and the green flashes are related to transmitted pings.
After an HR2 is powered, it performs a self-test and flashes both the green and red lights at the same
time, making the light look more of an orange colour. After these orange flashes, you will see either a
very long
green light to indicate the tests passed and all is well, or a long red light to indicate there was
a problem. If you see the long red light followed by more flashes, contact VEMCO for instructions.
When the transmit feature is enabled in the HR2, the status light will flash a quick flash for each ping
sent and a longer
green flash to indicate that the pings were recorded in the receiver memory.
LED event (on boot up or when starting a
study)
Means...
Steady WHITE light (~5 seconds) self-test
GREEN flash following steady white, and only
on boot up (not on starting a study)
self-test passed
RED flash following steady white, and only on
boot up (not on starting a study)
failed self-test
165
8.2 Status Light Flashes