A) Enter Programming Mode with Master Code (Exit-Factory Master Code: 0 0 0 0)
Entry of Master Code
Confirm
Comments
Set system to Programming Mode
NOTE:
Factory has put a master code
into the keypad before exit-factory, owner may take it
for first �me use.
B) System Refreshing to Single User Mode –
Installer Programming
(Default: 8 9 0 0, Single-user mode)
Refresh Code
Confirm
Comments
Clear all previously stored data and set keypad back to default values except
Master Code
C) Code Entries –
User Programming
1) Recording Master Code and User Codes –
User Programming
(No Default Codes)
Loca�ons
Entry of Codes
Confirm
Comments
4 digits fixed
Owner’s Master Code for se�ng system to programming mode
4 digits fixed
User Code for opera�ng Output 1
4 digits fixed
User Code for opera�ng Output 2
Programming Summary Chart for “Single-User Mode”
SET KEYPAD TO SINGLE USER MODE (to whom it may require)
This keypad also consists of a simplified version so�ware for code entry. It is single user mode for
those users only need one user code for each output and execu�ng each of the special func�ons.
Once the keypad is in single user mode, there is no User ID required for the codes, just simply enter
the code to each Loca�ons directly.
Single user mode is prepared for those users who need simple func�on and use the default values
for their keypad only. Please ignore this sec�on if it is not suitable for your applica�on.
Important Notes:
●
All user codes and master code must be 4 digits. The codes of more than 4 digits will be invalid.
●
Change the master code to 4 digits before refreshing the keypad to single user mode. Otherwise,
refreshing will be refused.
●
Refreshing takes 2-3 seconds to complete. Do not enter any code during refreshing un�l 2
confirma�on beeps are heard.
●
The keypad will be in auto code entry mode in default a�er it is refreshed to single user mode.
●
The keypad can be changed back to standard mul�-user mode with the system refreshing code 8 9 0 1.
●
Single user mode simplifies the procedures for code entry only. All programming procedures for
other features are exactly the same like in mul�-user mode and not affected.
●
See summary chart for the
“Single-User Mode”
programming procedures.
26
