CU2101/KIT
- 1 -
VELLEMAN
CU2101/KIT – PLUG & PLAY KIT FOR CU2101/CU2201
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the
CU2101/KIT
! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
•
All modifications of the device are forbidden and any ensuing damage is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
•
Protected the device against extreme heat, dust and moisture.
3. Contents
1. 220VAC/12VDC adapter
2. distribution block
3. UTP cable (2 x 5m included)
4. motion detector (1 included) or smoke detector or reed switch
(1 included)
5. key switch, motion detector, smoke detector or reed switch.
4. Preparation
1.
Place the SIM card in your mobile phone. Deactivate the PIN
code (see your mobile phone’s user manual).
2.
Erase all Telephone numbers on the SIM card.
3.
Remove and replace the SIM card.
4.
Enter the phone number to which the
CU2101
must call in case
of an alarm into
memory 1
.
5.
Remove the SIM card from the mobile phone and place it in the
CU2101
.
6.
Program the alarm telephone number of the
CU2101
which must be dialled into your mobile phone. Name that
telephone number (e.g. Alarm Unit).
7.
Connect a 12VDC/5mA power supply through either a power adapter or a battery. Never connect a battery
charger loading the
CU2101
with a battery.
8.
Connect the included UTP cable.
9.
Switch on the
CU2101
. The red LED lights. Switch off the
CU2101
.
10.
Connect the orange wire of the UTP cable to the COM of the sensor. Connect the orange/white wire of the UTP
cable to the NO. The
CU2101
will now dial the programmed telephone number. Accept the call and break off the
connection.
