Vega VEGAFLEX 61, Руководство по эксплуатации

Страница: 10 / 64

4
M ounting
4
.
1
G eneral instructions
M ake sure that all parts of the instrument exposed to the process , in
particular the sensor element , process seal and process fi tting , are
suitable for the existing process conditions . T hese include above all
the process pressure , process temperature as well as the chemical
properties of the medium .
Y
ou can fi nd the speci fi cations in chapter "
T
echnical data " or on the
type label .
S elect an installation position you can easily reach for mounting and
connecting as well as later retro fi tting of an indicating and adjustment
module . T he housing can be rotated by
330
° without the use of any
tools . Y ou can also install the indicating and adjustment module in four
di ff erent positions ( each displaced by
90
°
).
B efore beginning the welding work , remove the electronics module
from the sensor . B y doing this , you avoid damage to the electronics
through inductive coupling .
W ith threaded versions , the housing must not be used to screw in the
instrument ! A pplying tightening forces on the housing can damage its
internal parts .
U se the hexagon for screwing in .
U se the recommended cables ( see chapter " C onnecting to power
supply " ) and tighten the cable gland .
Y ou can give your instrument additional protection against moisture
penetration by leading the connection cable downward in front of the
cable entry
. R ain and condensation water can thus drain o ff . T his
applies mainly to outdoor mounting as well as installation in areas
where high humidity is expected
(
e
.
g
.
through cleaning processes
)
or
on cooled or heated vessels
.
S uitability for the pro -
cess conditions
M ounting position
W elding work
H andling
M oisture
10
VEGAFLEX
61
• P ro fi bus PA
4
M ounting
31835
-
EN
-
100426