41
6 Set up with the display and adjustment module
VEGAPULS 69 • Two-wire 4 … 20 mA/HART
47247-EN-200427
In the third view, the selected measured value as well as a second se-
lectable value, e.g. the temperature of the electronics, are displayed.
During the initial setup of an instrument shipped with factory settings,
use the "
OK
" key to get to the menu "
National language
".
This menu item is used to select the national language for further pa-
rameter adjustment. You can change the selection via the menu item
"
Setup - Display, Menu language
".
With the "
OK
" key you move to the main menu.
6.4 Parameter adjustment - Quick setup
To quickly and easily adapt the sensor to the application, select
the menu item "
Quick setup
" in the start graphic on the display and
adjustment module.
Select the individual steps with the
[->]
key.
After the last step, "
Quick setup terminated successfully
" is displayed
briefly.
Information:
The echo curve of setup is stored automatically during the quick
setup.
The return to the measured value indication is carried out through the
[->]
or
[ESC]
keys or automatically after 3 s
You can find "
Extended adjustment
" in the next sub-chapter.
6.5 Parameter adjustment - Extended adjustment
The main menu is divided into five sections with the following func-
tions:
Setup:
Settings, e.g., for measurement loop name, units, application,
adjustment, signal output
Display:
Settings, e.g., for language, measured value display, lighting
Selection of national
language
Main menu
