Veeder-Root TLS-50 Series, Руководство пользователя

Страница: 25 / 76

20
Applying Power to System
Cold Boot - Initial Power Up (Consoles w/Display)
Once all devices are connected to the console, attach the console power wires to the appropriate power panel
connections. Close the front panel of the console. Switch on the AC power breaker. The system will automatically
run a cold boot self-diagnostic program when you power up the console for the first time:
Test Passed Test Failed Action (If Failed)
RAM TEST - OK RAM FAIL
Replace CPU board
ROM TEST - OK ROM FAIL
“ “ “
COLD BOOT
EEPROM TEST - OK EEPROM FAIL
“ “ “
STARTUP COMPLETE
Following a cold boot the display will read:
NO TANKS CONFIGURED
Follow the Setup instructions in the TLS-50 Setup and Operation Manual to program the system.
Cold Boot - Initial Power Up (Consoles w/o Display)
Once all devices are connected to the console, attach the console power wires to the appropriate power panel
connections. Close the front panel of the console. Switch on the AC power breaker. The system will automatically
run a cold boot self-diagnostic program when you power up the console for the first time. Wait 30 seconds and
then follow the Setup instructions in the TLS-50 Setup and Operation Manual to program the system.
Test Failed Action (If Failed)
Unit fails to communicate Check “RS-232 Serial Communication Setup” on page 24. If comm settings are
correct, replace CPU board.
Cold Boot - RAM Clear
If the system has previously been setup, a cold boot can be initiated and the system reset (such as for a software
upgrade) as follows:
CONSOLES WITH DISPLAY
Move the RAM clear jumper (J3 in Figure 5) off of pins 1 and 2 and onto pins 2 and 3. The display will
acknowledge the RAM clear request with the message:
RAM CLEAR , then turn the power Off. Move the jumper
back onto pins 1 and 2.
CONSOLES WITHOUT DISPLAY
Turn off the power to the unit, move the RAM clear jumper (J3 in Figure 5) off of pins 1 and 2 and onto pins 2 and
3. Turn on the power for 5 seconds, then turn the power off. Move the jumper back onto pins 1 and 2.