Installation Guide
Safety Precautions
2
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup
the equipment discussed in this manual:
Installer Certification: Contractors holding valid Installer Certification are approved to perform wiring and
conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation; wireless
equipment installation; tank and line preparation; and line leak detector installation.
TLS-350 Technician Certification: Contractors holding valid TLS-350 Technician Certifications are
approved to perform installation checkout, startup, programming and operations training, system tests,
troubleshooting and servicing for all Veeder-Root TLS-300 or TLS-350 Series Tank Monitoring Systems,
including Line Leak Detection and associated accessories.
Wireless TLS Technician Certification: Contractors holding valid Wireless TLS Technician Certifications
are approved to perform installation checkout, startup, operations, troubleshooting and servicing for all
Veeder-Root TLS Wireless Systems, including the RF Console and associated accessories such as
transmitters, receiver and repeater.
Warranty Registrations may only be submitted by selected Distributors.
Probe Transmitter Considerations
Installation of this equipment in wet or below grade locations requires that the installer take steps to ensure
that the equipment is mounted above the maximum water level and install a suitable water pump for removing
water inside the applicable sump.
CAUTION! – The transmitter will not function properly in water. Also, submersion of the
transmitter in water can cause permanent damage to the internal electronics.
Related Documents
576013-623 TLS-3XX System Setup Manual
331940-012 TLS RF System Control Drawing
Safety Precautions
FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS AND SAFETY PRECAUTIONS COULD
CAUSE DAMAGE TO PROPERTY, ENVIRONMENT, RESULTING IN SERIOUS INJURY OR DEATH.
Retain and follow all product safety and operating instructions. Observe all warnings on the product and in the
operating instructions. To reduce the risk of bodily injury, electric shock, fire, or damage to the equipment,
observe the following precautions.
GENERAL PRECAUTIONS
Heed service markings: Opening or removing the console cover may expose you to electric shock.
Servicing of Veeder-Root equipment must be done by Veeder-Root authorized service contractors.
