6-17
6
Communications Setup
Auto-Dial Alarm Setup
REMAINING ALARM GROUPS
Continue to step through all of the available alarm groups, selecting the various alarms from the groups that you
want to send to the selected destination (D1, D2, etc.). The procedure for bypassing or selecting alarms from each
group and then assigning them to a device in that group is the same as discussed for In-Tank alarms above.
Only installed components will display, so some of the alarm groups shown below may not appear.
LIQUID SENSOR ALARMS
If necessary, press STEP until you see the message:
Select the Liquid Sensor Alarms to send (ref. Alarm List in Table 6-2).
VAPOR SENSOR ALARMS
If necessary, press STEP until you see the message:
Select the Vapor Sensor Alarms to send (ref. Alarm List in Table 6-2).
EXTERNAL INPUTS ALARMS
If necessary, press STEP until you see the message:
Select the External Inputs Alarm to send (ref. Alarm List in Table 6-2).
LINE LEAK ALARMS (VLLD)
If necessary, press STEP until you see the message:
Select the Line Leak (Volumetric) Alarms to send (ref. Alarm List in Table 6-2).
GROUNDWATER SENSOR ALARMS
If necessary, press STEP until you see the message:
Select the Groundwater Sensor Alarms to send (ref. Alarm List in Table 6-2).
D1: (Destination)
LIQUID SENSOR ALMS: NO
D1: (Destination)
VAPOR SENSOR ALMS: NO
D1: (Destination)
EXTERNAL INPUTS: NO
D1: (Destination)
LINE LEAK ALARMS: NO
D1: (Destination)
GROUNDWATER ALMS: NO
