19
The Insite360 Connect’s POS communication parameters shown below are defaults and may have changed;
these parameters must match the site’s POS communication parameters. Consult the customer’s IT
department for the site’s actual POS communication parameters.
Replacing The Insite360 Connect
When a Insite360 Connect cannot push information to the cloud, it should be replaced with a similar device
that has been pre-configured and registered with the GVR Cloud in the same way the original device was. Any
information recorded on the old device that was not sent to the Cloud may be lost or duplicate data may be
sent to the GVR Cloud.
Veeder Root
Baud Rate
9600
Data Bits
7
Parity
Odd
Stop Bits
1
Save
Network
POS
Default BIR Protocol EDIM POS communication parameters shown above.
Default Gilbarco EDIM POS communication parameters are: 1200, 7, Even, 1
NOTICE
