Introduction
Contractor Certification Requirements
4
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
Installer (Level 1) Certification:
Contractors holding valid Installer Certification are approved to perform wiring and
conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation; wireless equipment
installation; tank and line preparation; and line leak detector installation.
ATG Technician (Level 2/3 or 4) Certification:
Contractors holding valid ATG Technician Certifications are approved
to perform installation checkout, startup, programming and operations training, system tests, troubleshooting and
servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak Detection. In addition, Contractors
with the following sub-certification designations are approved to perform installation checkout, startup, programming,
system tests, troubleshooting, service techniques and operations training on the designated system.
• Wireless 2
• Tall Tank
Warranty Registrations
may only be submitted by selected Distributors.
Safety Precautions
The following safety symbols may be used throughout this manual to alert you to important safety hazards and
precautions.
GENERAL
Ensure that all local council and regulations are complied with. Also ensure that all recognized safety codes are
followed.
EXPLOSIVE
Fuels and their vapors are extremely explosive if ignited.
FLAMMABLE
Fuels and their vapors are extremely flammable.
ELECTRICITY
High voltage exists in, and is supplied to, the device. A
potential shock hazard exists.
TURN POWER OFF
Live power to a device creates a potential shock
hazard. Turn Off power to the device and associated
accessories when servicing the unit.
WARNING indicates a hazardous situation
which, if not avoided, could result in death or
serious injury.
USE SAFETY BARRICADES
Unauthorized people or vehicles in the work area are
dangerous. Always use safety cones or barricades,
safety tape, and your vehicle to block the work area.
INJURY
Careless or improper handling of materials can result in
bodily injury..
GLOVES
Wear gloves to protect hands from irritation or injury.
WEAR EYE PROTECTION
Wear eye protection when working with pressurized
fuel lines or epoxy sealant to avoid possible eye injury.
WEAR RESPIRATOR
Wear breathing protection when working in the
presence of harmful vapors.
READ ALL RELATED MANUALS
Knowledge of all related procedures before you begin
work is important. Read and understand all manuals
thoroughly. If you do not understand a procedure, ask
someone who does.
NOTICE is used to address practices not
related to physical injury.
OFF
WARNING
NOTICE
