6
20. Operate switch to ensure proper operation of spotlight.
REPLACING THE BATTERY PACK
The sealed lead acid battery has a life of several years, if recharged promptly after each use.
When a fully charged battery only provides about ten minutes or less of spotlight operation,
it should be replaced with a new one. To replace the battery, you will need a narrow shaft Phil-
lips-head screwdriver and a replacement battery. The battery pack can be replaced by doing
the following:
1. Complete the bulb replacement steps through step 5, to remove the reflector assembly.
2.
Remove the three Phillips-head screws (clockwise) that fasten the two halves of the
housing
body. (see Figure 1 for locations).
3.
Separate the two body halves and carefully pop out the handle, stand and recharge
port assemblies.
WARNING:
DO NOT ALLOW BARE WIRES OR CONNECTORS TO CONTACT EACH OTH-
ER;
DANGEROUS SPARKING CAN OCCUR
4.
Note polarity of battery. Note which color wire is on which terminal.
5.
Disconnect the wires from the battery and set the battery aside.
6.
Connect the replacement battery, making sure the correct color wires are on the new
battery terminals. Make sure POS (+) is red and NEG (-) is black.
CAUTION:
Incorrectly connected wires will allow the spotlight to operate normally, however,
when recharge adapters are connected, there will be damage to the battery and recharge
adapters. Double check battery polarity before reassembly!
7.
Replace handle, stand and recharge port assemblies in one half of the housing body.
Make sure wires and connectors do not touch.
8.
Place other half of housing body into position and replace three screws (clockwise).
Do not overtighten.
9.
F o l l o w s t e p s 1 4 t h r o u g h 2 0 f o r b u l b r e p l a c e m e n t
to reassemble reflector, rubber “O” ring,
glass, retaining ring and rubber bezel. Charge the new battery using AC recharge
adapter for a minimum of 18-20 hours initially, then 15 hours thereafter.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed
of properly. Recycling is required, contact your local authority for information. Failure to
comply with local, state and federal regulations can result in fines or imprisonment.
Battery Disposal Warnings:
• Do not dispose of the battery in fire as this may result in an explosion
• Before disposing of the battery, protect exposed terminals with heavy-duty
electrical tape to prevent shorting (shorting can result in injury or fire)
• Do not expose battery to fire or intense heat as it may explode
• For more information on recycling this battery, call toll-free (877) 288-7722
7.
SPECIFICATIONS
Spotlight Bulb..........................................................................................12 volt, H3 series
Battery ......................................... Maintenance free, sealed lead acid, 12 volt, 3 amp Hour
Weight ............................................................................................... 3 lbs 2 oz (1.45 kg)
Length ..................................................................................................... 8.5 in (21.6 cm)
Width ...................................................................................................... 6.0 in (15.2 cm)
Height (folded) ........................................................................................ 6.5 in (16.5 cm)
RECYCLE NON-
SPILLABLE LEAD
ACID BATTERY
