5
Using the Built-In Workstand
Turn the Spotlight upside-down on a smooth even surface, and rest it on the
Workstand.
Using the Built-In Carry Lanyard
The Carry Lanyard may be used to store or carry the Spotlight. Adjust the slide on
the cords to keep the Lanyard secure around the supporting object.
SPOTLIGHT BULB REPLACEMENT
To replace the H3 type 12 volt bulb, you will need a small Phillips type screwdriver
and a replacement bulb. Bulb life can be shortened by installing a bulb with dirt or
fingerprints on it. The bulb can be wiped clean with a cloth moistened with alcohol.
During bulb installation, avoid touching the glass part of the bulb. (See Figures 1A
and 1B for details.)
1. Disconnect the unit from any charging adapter.
2. Push back the rubber bezel toward the back of the spotlight to reveal two small
Phillips screws in the retaining ring.
3. Using the screwdriver, remove (counterclockwise) the two screws. Set them
aside.
4. Lift off the retaining ring, glass lens and rubber "O" ring and set them aside.
5. Carefully remove the reflector and bulb assembly (see Figures 2A and 2B).
6. Disconnect the bulb wire from the red power wire and set aside the burned out
bulb.
Figure 1A
RETAINING RING
RUBBER
“O” RING
REFLECTOR
RUBBER
END
CAP
RUBBER GUARD COVER
TRIGGER LOCK
SWITCH
TRIGGER
QUARTZ HALOGEN
BULB
CARRY
LANYARD
BUILT-IN
WORKSTAND/
CARRY HANDLE
4
2. Recharge for 3-4 hours maximum or until the green Battery Charge Level LED
Indicator lights when the Battery Level Display pushbutton is pressed.
3. After recharge, disconnect the Adapter from the external charging/power
source, then disconnect the connector from the DC Recharge Port.
Note:
Some vehicles must have the ignition turned on to power the vehicle’s
accessory outlet.
WARNING
• NEVER SIMULTANEOUSLY CONNECT AC/DC AND DC/DC CHARGERS
TO SPOTLIGHT.
Operating the Spotlight
To turn the Spotlight ON, squeeze the Trigger. To turn the Spotlight OFF, release the
Trigger.
To lock the Trigger in the ON position, squeeze the Trigger and move the Trigger Lock
Switch (located on the side of the handle) to the “locked” position. The Spotlight will
stay on until the lock is moved to the “unlocked” position and the Trigger released.
Operating the LED Area Lights
The ON/OFF Button for the LED Area Lights is located on the top of the Spotlight.
ON/OFF BUTTON FOR
LED AREA LIGHTS
TRIGGER
TRIGGER LOCK
SWITCH
BATTERY CHARGE
LEVEL LED INDICATORS
VEC157CL_157CFL_Manual_061505 6/29/05 4:22 PM Page 4
