1
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES
READ ALL INSTRUCTIONS
WARNING:
Read and understand all instructions before operating product. Failure to
follow all instructions listed below may result in electric shock, fire and/or serious injury.
•
AVOID DANGEROUS ENVIRONMENT.
Don’t use appliances in damp or wet locations.
Don’t use appliances in the rain.
•
KEEP CHILDREN AWAY
. All visitors should be kept at a distance from work area.
•
STORE IDLE APPLIANCES INDOORS.
When not in use, appliances should be stored
indoors in dry, and high or locked-up place – out of reach of children.
•
DON’T FORCE APPLIANCE.
It will do the job better and with less likelihood of a risk of
i n j u ry at the rate for which it was designed.
•
USE RIGHT APPLIANCE.
Do not use the appliance for any job except that for which it is intended.
•
DRESS PROPERLY
. Do not wear loose clothing or jewelry. They can be caught in moving
parts. Rubber gloves and substantial, non-skid footwear are recommended when working
outdoors. Wear protective hair covering to contain long hair.
•
USE SAFETY GLASSES AND OTHER SAFETY EQUIPMENT.
Use safety goggles or safety
glasses with side shields, complying with applicable safety standards and, when needed, a face
shield. Also use face or dust mask if operation is dusty. This applies to all persons in the work
area. Also use a hard hat, hearing protection, gloves, safety shoes and dust collection systems
when specified or required. Safety glasses or the like are available at extra cost at your local
dealer or Black & Decker Service Center.
•
DON’T ABUSE CORD.
Never carry appliance by cord or yank it to disconnect from
receptacle. Keep cord from heat, oil, and sharp edges.
•
DON’T OVERREACH.
Keep proper footing and balance at all times.
•
DISCONNECT APPLIANCES.
Disconnect the appliance from the power supply when not in
use, before servicing, and when changing accessories such as blades and the like.
•
AVOID UNINTENTIONAL STARTING.
Don’t carry plugged-in appliance with finger on
switch. Be sure switch is off when plugging in.
•
GROUND FAULT CIRCUIT INTERRUPTER (GFCI)
protection should be provided on the
c i rcuits or outlets to be used. Receptacles are available having built in GFCI protection and
may be used for this measure of safety.
•
USE OF ACCESSORIES AND ATTACHMENTS.
The use of any accessory or attachment not
recommended for use with this appliance could be hazardous. Note: Refer to the accessory
section of this manual for further details.
•
STAY ALERT.
Watch what you are doing. Use common sense. Do not operate tool when
you are tired.
•
CHECK DAMAGED PA RT S .
Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of moving parts, breakage of
parts, mounting, and any other conditions that may affect its operation. A guard or other part
that is damaged should be properly repaired or replaced by an authorized service center unless
o t h e rwise indicated elsewhere in this instruction manual. Have defective switches replaced by
authorized service center. Do not use tool if switch does not turn it on and off.
SL101MV ManualEN 101007.qxp 9/26/08 12:44 PM Page 1
