87
©Vecow RCX-1000 User Manual
GETTING TO KNOW YOUR RCX-1000
2.5.3 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin plugable
terminal block located on the front panel. Please use the following pictures to
find the general wiring configuration.
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
Note :
1.
DC power source and IGN share the same ground.
2.
RCX-1000 supports 6V to 36V wide range DC power input in ATX/AT
mode. In Ignition mode, the input voltage is fixed to 12V/24V for car battery
scenario.
3.
For proper ignition control, the power button setting should be "Power Down"
mode.
In Windows for
example, you need
to set "When I press
the power button" to
Shut down.
Pin No.
Definition
1
Ignition
2
SW+
3
SW-
IGN
IGN
V+
V-
