1.3 Sensors
1.3.2
Temperature Sensor for Oil
❒
Sensor installation location: At the place provided by the engine manufacturer, equipment manufacturer or car manu-
facturer in the oil circulation system (e. g. oil drain plug).
❒
Sensor installation only when engine is cold.
❒
When removing the oil drain plug, collect the oil running out of the system in a proper container and dispose of it in ac-
cordance with legal regulations.
max.
❒
The values mentioned in the following table for the maximum tightening tor-
que (Nm max.) refer exclusively to the load-bearing capacity of products.
Prior to using the product, it is important to ask the manufacturer of the ve-
hicle, equipment system or engine in each instance for the maximum tor-
que (? Nm max.) value for the threaded hole into which the product is to be
screwed. Non-observance of the maximum tightening torque specified for
the threaded hole in each instance can result in damage to the vehicle, en-
gine or equipment system.
❒
If the connection thread is cylindrical, a sealing washer or a sealing ring made of copper must be fitted.
❒
Following sensor installation, fill up the system with the required quantity of specified oil.
1. Safety Instructions
M10 x 1
10 Nm
M10 x 1.5
10 Nm
1/8 - 27 NPTF
10 Nm
M12 x 1.5
15 Nm
1/2 - 20 Gang
15 Nm
M14 x 1.25
20 Nm
M14 x 1.5
20 Nm
5/8 - 18 UNF - 3A
20 Nm
1/2 In. 20 Whit. S
20 Nm
1/4 - 18 NPTF
20 Nm
M16 x 1.5
30 Nm
M18 x 1.5
30 Nm
M20 x 1.5
30 Nm
M22 x 1.5
30 Nm
M24 x 1.5
30 Nm
M26 x 1.5
30 Nm
1/2 - 14 NPTF
30 Nm
3/8 - 18 NPTF
30 Nm
R 1/2
30 Nm
R 3/8
30 Nm
3/8 - 18 Dryseal NPTF
30 Nm
3/4 - 16 UNF-3A
30 Nm
Product Manual
Technische Änderungen vorbehalten Technical details subject to change
1 - 6
TU00-0736-0000002
0609
Содержание CANcockpit Series
