VCS VIP 1000, Руководство пользователя

Страница: 73 / 118

Chapter 7 Configuring the Receiver
VIP 10 / VIP 1000 73
Number of video receiver address:
The VIP can store up to 10 IP addresses, which are polled in response to an
alarm. When an alarm signal is received, the unit attempts to contact the first IP
address. If this address cannot be reached, the others will be tried in sequence
until a connection can be established. Select the contact priority of the IP address
here.
Alarm IP address:
Enter the IP address to contact in the event of an alarm.
Remote password:
Enter the password for the remote device (if it has one) that is to be contacted in
response to an alarm.
Live video auto-connect:
Select On here if an active connection should be established after each reboot,
for example following a connection failure or power failure.
Relay action / Relay operation
You can configure the switching behavior of the relay output. Open switch relay
mode (normally closed contact) or closed switch relay mode (normally open
contact) can be specified here.