VCS VIP 10, Руководство пользователя

Страница: 76 / 122

Configuring the Receiver Chapter 7
76 VIP 10
Alarm connections
You can select a number of options for the response of the VIP to an alarm. In
case of an alarm, the VIP can establish a connection to a predefined IP address,
e.g. a VIP sender, automatically. You can enter up to 10 IP addresses which will
be selected in sequence by the unit until a connection is established.
Note
Sender and receiver must share the same subnet for connection set-up
(see page 81).
If the VIP connects to a "dual streaming“ encoder Stream 1 will be
transmitted.
Connect on alarm:
Select On , to establish a connection automatically to a specified IP address in the
event of an alarm.
With the setting Follows input , the VIP holds the automatically set up connection
to a remote location as long as an alarm signal is present at its alarm input 1. You
can use this setting to establish a connection between two VIP units via a
connected on-off switch. In this case you don’t need a computer to set up the
connection.
Number of destination IP address:
Here you assign the numbering for the IP addresses to be contacted in the event
of an alarm. The unit contacts the remote locations one after the other in the
numbered sequence until a connection has been established.