vc999 593.767, Оригинальное руководство по эксплуатации

Страница: 45 / 96

Shrink Tunnel VC999 ST2/ST2 D
Operation
2009-11-12
Art. no. 593.767 Page 45/96
NOTICE
The symbol means that the program has been pre-programmed as "continuous operation"
by the manufacturer and cannot be overwritten. For more information, refer the description in
the section "Continuous operation".
Saving program (only possible from safety level 1 and
higher)
Save newly defined or changed program parameters as follows:
•
Press the right-hand symbol. The program overview ap-
pears.
•
Press the number of the program you wish to overwrite.
Fig. 9/13
•
Answer the displayed safety query: Overwrite program X? Press:
Do not overwrite program
The program is not overwritten and the entered data are
not saved. Return to the program overview.
Overwrite program
The selected program is overwritten and saved with the
entered data. Go to the "Water temperature" mask.
9.4.2 Operating hours meter
Press the Operating hours meter symbol (on main menu
page 1) to access further sub-menus which can be opened
one after the other via the arrow buttons.
These display the operating hours of various components and
devices (if installed) as well as the total operating hours of the
machine.
Fig. 9/14
Total
Total operating hours of the machine
Drive left
Refers to the conveyor belt (optional) on the left-hand side of the machine as viewed
from the control panel. It can be either an infeed or outfeed belt.
Transport
Conveyor belt inside the machine (internal)
Drive right
Refers to the conveyor belt (optional) on the right-hand side of the machine as
viewed from the control panel. It can be either an infeed or outfeed belt.
Heater 1-3
Refers to the electric immersion heaters in the water tank. Refer to the circuit dia-
gram for numbering allocation (1-3).
Steam heater
If the machine is connected to a central steam generation unit, this operating time
refers to the integrated steam distributor (optional).