ASSEMBLY AND INSTALLATION
INSTRUCTIONS
T0435
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
1. Energy saving fixture.
2. Use the dim-to-bright illumination option
where you want some minimum illumination
through out the night, such as at your front
entrance or garage door. Use the dark-to-bright
illumination option where you do not need
minimum brightness, such as the backyard
or back porch.
3. When in manual override mode, use wall switch
to keep the light ON till dawn.
Important to Know
1. Read all instructions carefully before installation and
operation.
2. If you are not familiar with state and local electrical codes,
it is recommended that you consult with a qualified
electrician.
3. Before installation, shut off power at the main fuse or
circuit breaker box. Be aware that simply turning off the
wall switch is not sufficient to prevent an electrical shock.
4. This fixture requires a 120 VAC, 60 Hz power source.
5. Do not attempt to take the lantern apart; there are no
serviceable parts inside.
6. To avoid sensor damage by lightning or electrical surge,
make sure the grounding wire is securely connected.
Maximum Wattage: 60W Incandescent Bulb
Work Temperature: - 4°F~104°F
Features
Page 1 of 6
180726
AA
BB
CC
DD
EE
FF
GG
HARDWARE CONTENTS Note: Hardware not shown actual size.
Mounting Screw
X2
Lock Nut
X4
Ball Nut
X2
Wire Connector
X3
Rubber Pad
X2
Cross Bar
X1
Headless Screw
X2
