To replace or purchase parts
for your vacuum cleaner,
please visit our website:
vax.co.uk
If your Vacuum Cleaner or
Accessories are Damaged/Faulty
Please Call our Vax Careline on:
IMPORTANT :
Always switch off and unplug the vacuum cleaner from the electrical
outlet before removing the Dirt Container.
Safety Information
For Household Use Only
When using the vacuum cleaner, basic safety
precautions should always be observed, including
the following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains
supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose
and accessories.
4. Children should be supervised to ensure that
they do not play with the appliance.
5. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
6. Use only as described in this manual.
Use only the manufacturer’s recommended
attachments.
7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord or plug is
damaged, return the vacuum cleaner to a Vax
Authorised Service Agent or suitably qualified
person for examination, repair or adjustment.
8. Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or pull
the cord around sharp edges or corners. Do not
run the vacuum cleaner over the cord. Keep the
cord away from heated surfaces.
9. Do not handle the plug or vacuum cleaner with
wet hands. Do not use outdoors or on wet
surfaces.
10. Do not put any objects into openings. Do not
use with any openings blocked and do not
restrict air flow. Keep all openings free of dust,
lint, hair or anything that may reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of
the body away from openings and moving parts.
12. Do not pick up hot coals, cigarette butts,
matches or any hot, smoking or burning objects.
13. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene, etc) or use in the
presence of explosive liquids or vapours.
14. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
15. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
16. Do not use without the filters in place.
17. Take extra care when vacuuming on stairs.
18. Keep vacuuming area well lit.
19. Store the vacuum cleaner indoors in a cool, dry area.
20. Turn off the on/off switch before unplugging
the vacuum cleaner.
21. Use only CE-approved 13 amp extension cords.
Non-approved extension cords may overheat.
Care should be taken to arrange the cord so
that the cord cannot be pulled or tripped over.
WARNING:
Always switch off and unplug
the vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.
CAUTION:
The vacuum cleaner is a very
powerful unit. Before plugging the cord into
the electrical outlet, make sure the switch is in the
‘off’ position. Hold the vacuum cleaner firmly when
starting and in use.
IMPORTANT:
If the inlet, hose or telescopic
tube is blocked, switch off the vacuum
cleaner and remove the blockage(s) before
re-starting the vacuum cleaner.
IMPORTANT:
Washing filters improves
vacuum performance. Make sure all the
filters are completely dry before inserting back into
the vacuum cleaner.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
1. Parts Overview
The Unit
1
On/Off Button
Insert the plug into the electrical outlet.
Press the on/off switch on the top of
the vacuum cleaner, to switch the
vacuum cleaner on and press the
button again to turn the vacuum
cleaner off.
2
Dirt Container
Locked on to the top of the unit.
3
Cyclone separator
Located inside of the Dirt container.
4
Pre-motor filter cover
Push the handle catch up to gain
access to the filter.
5
Dirt container /Carry handle
Use the carry handle located on the top
of the dirt bin to move the vacuum
cleaner from room to room.
6
Dirt container release button
Press the release button and the dirt
container can be lifted and removed off
the unit.
7
Auto cord rewind
To rewind the power cord, press the
cord rewind button located at the rear
of the vacuum cleaner.
8
Floor Tool parking storage
For convenience there is a parking slot
located at the rear of the vacuum
cleaner where the Floor Tool can be
parked for carrying and storage.
9
Post Motor filter cover
Slide the latch across to gain access to
the filter.
10
Plug
11
Dirt bin quick release button
Hold the dirt bin container over a bin
and press the release button.
12
Hose inlet
FAQs
Cleaning the Pre-Motor Filter
Cleaning the Post-Motor Filter
8. Cleaning Blockages
Turn the vacuum cleaner off and unplug from the electrical outlet.
HOSE BLOCKAGES:
The flexible hose may be disconnected from the vacuum cleaner by pressing the clip
on the connector and pulling away from the machine. Carefully remove any blockages found and
reconnect the hose securely.
ACCESSORY BLOCKAGE:
Remove the accessories from the cleaner, carefully remover the
blockage and return to the cleaner.
Clearing Debris from the TurboTool
Removing debris from the TurboBrush
The brushbar will stop rotating if it is blocked during operation
by vacuuming up foreign objects, or if strands of carpet are
wrapped around it. Switch the vacuum cleaner off and
disconnect the power plug from the electrical outlet.
Lay the TurboBrush floor head on a flat surface and turn over
to expose the brushbar. Using a pair of scissors, cut through
any threads or hairs caught by the brushbar that have
wrapped around the guides.
3
Bagless cylinder
Vax model number:
C91-M3 Series
GB
instruction manual
Retain this guide for future reference.
!
!
!
!
IMPORTANT:
Always unplug the vacuum from the electrical outlet and rewind the
power cord as directed before storing.
NOTE:
When rewinding the power cord, guide the cord with one hand, This will prevent the
cord from whipping which could cause damage or injury.
NOTE:
For convenience there is a parking slot located at the rear of the vacuum cleaner where
the floor tool and hose can be parked for carrying and storage.
!
!
CLICK!
CLICK!
CLICK!
CLICK!
Monday-Friday 8.30am to 6.30pm Saturday-Sunday 9.00am to 5.00pm
Any queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the UK
national rate.
Please make a note of the model number and serial number of your Vax before calling. There
are over 400 approved Vax Service Agents in the UK. For the nearest Vax Service Agent,
please call the Vax Careline or visit vax.co.uk
Technical Specification
Voltage:
220 - 240 ~ 50 Hz
Wattage:
1400W
Capacity:
1.5 litres approx
Filters:
Cyclone separator – wipe clean
Pre-motor filter – washable
HEPA Post-motor filter – washable
Cord Length:
6m (approx)
Weight:
5.5 Kg (approx)
W
ha
t
is
yo
ur
va
x’
s
se
ri
al
nu
m
be
r?
N
ot
e
th
is
do
w
n
in
ca
se
yo
u
ne
ed
it
in
fu
tu
re
(o
n
th
e
ba
se
of
yo
ur
cl
ea
ne
r)
W
ha
t
is
yo
ur
va
x’
s
m
od
el
nu
m
be
r?
N
ot
e
th
is
do
w
n
in
ca
se
yo
u
ne
ed
it
in
fu
tu
re
(o
n
th
e
ba
se
of
yo
ur
cl
ea
ne
r)
-
-
-
Motor Thermostat
IMPORTANT:
The motor is equipped with a
thermal cut-out. If for any reason, the
vacuum cleaner should over-heat, the thermostat
will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the
electrical outlet and turn off the switch. Remove
the dirt container and empty. Clean the filters.
Allow the cleaner to cool for approximately one (1)
hour. To re-start, plug into an electrical outlet and
switch back on.
!
KEEP YOUR VAX LIKE NEW!
20
Foam Pre-Motor Filter
21
Fibre Pre-Motor Filter
22
Antibacterial Post-Motor Filter
IMPORTANT:
The condition of the filters affects the
performance of your vacuum cleaner. Please check
and wash filters periodically (depending on level of
use). For full cleaning instructions see page 4.
!
14
15
18
17
18
12
16
16
13
14
16
15
!
WARNING:
to reduce the risk of personal injury, unplug the vacuum cleaner before
performing maintenance/troubleshooting checks.
I
s there an accessory missing?
•
check the ‘Parts Overview’ page in this
guide to make sure that the part is
definitely included with your unit.
•
If it is missing, please call our Vax Careline
to order a replacement:
visit
vax.co.uk
to order online.
Why won’t the vacuum cleaner pick up?
•
The filters may be clogged: Refer to ‘The
Filters: Maintenance’ (Page 4).
•
The Dirt Container is full or blocked: Refer
to ‘Dirt Container: Maintenance’ (Page 4).
•
The Dirt Container may be incorrectly
installed: Refer to ‘Dirt container:
Maintenance’ (Page 4).
Why is dust escaping from the vacuum?
•
The filters may not be installed correctly.
Refer to ‘The Filters: Maintenance’ (Page 5).
•
The Dirt container may be incorrectly
installed: Remove the Dirt Container from
the unit by pressing the Dirt Container
Release Button (6) and reattach it to the
unit, ensuring it is locked firmly back into
place.
•
The filters may be clogged: Refer to
‘The Filters: Maintenance’ (Page 4).
What do I do if an accessory/the unit
becomes damaged or broken?
•
Visit www.vax.co.uk for parts and spares.
•
Please call our Vax careline to purchase
new spares or order a replacement:
Why won’t the accessories pick up
properly?
•
The accessory may be blocked: Refer to
‘Cleaning Blockages’ (Page 5).
•
The accessory may be faulty: call our
Vax Careline to order a replacement:
Why will the vacuum cleaner not run?
•
It may not be plugged into the electrical
outlet correctly: Ensure that the plug is
pushed into the electrical outlet securely.
•
The electrical outlet may not be working:
Check the fuse or breaker and consult an
electrician.
•
The motor Thermostat may have tripped:
Switch off and unplug the vacuum cleaner.
Leave for one hour before switching the
vacuum cleaner back on.
If none of these questions apply to you, or
for further assistance please call our Vax
Careline team on:
24
Replacement filter kits are available on: www.vax.co.uk
Your Filters:
15
16
Parts Overview
The Accessories
13
2-in-1 Tool
a. Dusting Brush: For delicate surfaces.
b. Upholstery Tool: For carpet, upholstery
and stairs etc.
14
Crevice Tool
For crevices, corners and cracks.
15
TurboBrush
Vacuums carpets & grooms pile.
Great for picking up pet hair.
16
Telescopic Tube
The telescopic tube can be lengthened
or shorted by pushing the button in and
sliding the tube apart or together as
required.
17
TurboTool
Great for picking up pet hair, vacuuming
stairs & upholstery.
NOTE:
Do not use the TurboTool on
suede and leather surfaces.
18
Hose
Tool caddy on handle for tool storage.
19
Hard Floor Tool
For parquet and laminate flooring.
EEC STATEMENT OF COMPLIANCE
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the
C91-M3 Series Mach 3 range is manufactured in compliance with the following Directives:
Safety:
2006/95/EC Low Voltage Directive
EMC:
2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Subject to technical
change without notice
1
2
3
5
3
2
4
12
4
5
6
7
8
11
9
10
17
19
13a
13b
NOTE:
Fully unwind the
power cord. A yellow mark
on the power cord
indicates the
recommended cord length.
Do not exceed the cord
length beyond the red
mark.
IMPORTANT:
Remove the Dirt Container
from the unit and dispose of the dirt
inside the container before cleaning.
IMPORTANT :
The cyclone separator should
not be submerged in water.
6. Dirt Container: Maintenance
Emptying the Dirt Container
Cleaning the Cyclone Separator
7. The Filters: Maintenance
!
IMPORTANT :
Do NOT use the vacuum
without ALL of the filters in place.
Vax recommends that the pre- and post-
motor filter should be checked and cleaned
periodically depending on the frequency of
use and the volume of dirt being picked up
on each occasion.
NOTE :
Both Pre- and Post-Motor Filters can
be rinsed in warm water (max 40°C). Allow to
air dry for 24 hours before replacing. Do NOT
use any detergents or boiling water to wash
filter.
!
IMPORTANT:
Your vax vacuum cleaner is fitted with high performance filters it is essential
that these are well maintained and cleaned according to the following instructions.
!
!
22
20
21
2. Assembling the vacuum cleaner
3. Choose the attachments for the job:
4. Operating the appliance
5. Packing away and storage
19
WARNING:
Always
switch off and
unplug the vacuum
cleaner from the electrical
outlet before assembling,
opening or emptying the dirt
container, or before
connecting/ disconnecting
the attachments.
!
24
Once completely dry, return the pre-motor filters and case to the vacuum cleaner.
Replace the pre-motor filter cover before restarting the vacuum cleaner.
18
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
vax.co.uk
(UK) 0844 412 8455 (ROI) 1-800 928 308
0844 412 8455
0844 412 8455
0844 412 8455
0844 412 8455
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
C-91-M3-G-A User Guide:Fold Out 17/4/09 15:36 Page 1
