Instructions For Use
If you require any further assistance or advice about any
VAX please call VAXCARE on
1300 36 4040
(Australia -
cost of a local call)
and
0800 800 900
(NZ)
296 Victoria Road Malaga Western Australia 6090.
EMAIL: [email protected]
WEBSITE: www.vax.com.au
VAXCARE
Please register your warranty.
Send in your completed Warranty Card.
VAX Appliances (Australia) Pty Ltd
A.C.N. 009099736
• NSW/ACT
Unit 2, 30 Heathcote Road,
Moorebank, New South Wales 2170
Ph: (02) 9602 6800 Fax: (02) 9602 6900
• VICTORIA/TASMANIA
Unit 3, 46 Burgess Road,
Bayswater North, Victoria 3153
Ph: (03) 9761 7160 Fax: (03) 9761 7175
• SOUTH AUSTRALIA/
NORTHERN TERRITORY
Unit 3, 75-77 Grange Road,
Welland, South Australia 5007
Ph: (08) 8340 2222 Fax: (08) 8346 7933
• QUEENSLAND
186 Kerry Road,
Archerfield, Queensland 4108
Ph: (07) 3216 7350 Fax: (07) 3216 7375
• WESTERN AUSTRALIA
296 Victoria Road,
Malaga, Western Australia 6090
Ph: (08) 9247 8100 Fax: (08) 9247 8192
• VAX APPLIANCES NEW ZEALAND
27 Clemow Drive
Mt Wellington, Auckland
Ph: (09) 5736220 Fax: (09) 5736224
Email: [email protected]
AUST. & NZ BRANCHES
M
O
D
IF
IE
D
F
E
B
2
00
7
P
/N
5
94
10
Please read instructions in full
before using this appliance.
Replacement Filters
Replacement filters are available from your
Vax stockist or Vax direct. Phone Vaxcare or
visit: www.vax.com.au
VAXCARE Service & Help:
AUSTRALIA 1300 36 4040
NEW ZEALAND 0800 800 900
If you have any queries or concerns about using
your Vax, call VAXCARE.
Please make a note of the serial number and
model number of the appliance before calling.
(Aust only: Mon-Fri. 10.00am to 6.00pm. EST)
Calls are charged at the local rate.
An answerphone is available outside of these
hours.
There are over 300 approved Vax Service Agents
in Australia and New Zealand. For the nearest
Service Agent, please refer to your Vax warranty
or call VAXCARE or visit www.vax.com.au
Vaxcare:
AUST: 1300 36 4040
NZ: 0800 800 900
www.vax.com.au
Installation
Insert the charging bracket into
the floor stand and connect the
charger to the floor stand (Fig.1).
Connect the swivel nozzle to the
main body (Fig.2).
Put the floor unit on the floor
stand for recharging (Fig.3)
Fig.3
Fig.1
Fig.2
IMPORTANT:
For maximum
Ni-Cd battery life and to
avoid memory effect, fully
discharge the battery
(by running down) then
completely re-charge at
least once a month.
