Vauni CI, Руководство пользователя

Страница: 16 / 40

14
© Copyright 2010 Vauni AB - All rights reserved
• The burner is dirty.
Measures:
• Ex• nguish the fl ames and let the burner cool for 15 minutes.
• Posi• on the burner again in a room that fulfi ls the requirements specifi ed in Sec• on 4 Firing .
• Change the fuel. See Sec• on 4.2.1 for recommenda• ons.
• Clean the burner system by following the instruc• ons in Sec• on 6.2.
The burner does not go out when the control is turned to the stop posi• on
Possible causes:
•
The regulator lid is blocked.
• The regulator lid is incorrectly placed.
• The regulator mechanism has been damaged by external infl uence, such as the burner being
dropped on the ground.
Measures:
•
Test by pushing the regulator lid to the maximum posi• on and then hard to the stop posi• on.
• If this does not work, let the burner burn out and then let it cool for at least 15 minutes.
• Check that the regulator lid is correctly placed (see instruc• ons in Chapter 3.1 Assembly and
installa• on).
• Check that no foreign object is blocking the mechanism’s movements, by li! ing out the burner
module.
• If the above does not help, contact the place of purchase for further contact with a service
technician.
The fl ame burns uncontrollably for some reason
Possible causes:
•
A fault has occurred in the burner system.
• The wrong type of fuel is being used.
• The burner is exposed to a very strong draught.
• The burner is not installed in accordance with the instruc• ons in Chapter 3.1 Assembly and
installa• on.
Measures:
The burner is designed and built, as well as thoroughly tested, to func• on safely even in abnormal
situa• ons. In the unlikely event that the burner burns uncontrollably, the recommenda• ons are as
follows:
•
Try to ex• nguish the fi re by closing the regulator lid.
• If this has no eff ect, the burner should primarily be allowed to burn out – provided that the
fl ames stay inside the intended space.
• If the fl ames are so strong that the burner cannot be allowed to burn out, it must be ex• nguished
with a hand-held fi re ex• nguisher. For more informa• on about suitable models of fi re
ex• nguisher, contact the rescue service (in Sweden, www.raddningsverket.se).
The regulator lid does not fi t • ghtly against the burner module
Possible causes:
•
The regulator lid is wrongly posi• oned.
• A foreign object is present between the regulator lid and the burner module.
• The regulator lid and/or the burner module is dirty.
Measures:
•
Posi• on the regulator lid according to the instruc• ons in Sec• on 3.1
Assembly and installa• on
.
• Remove any foreign objects.
• Li! off the regulator lid and clean it. If necessary, also clean the burner module and the burner
opening.