POWXG6461
EN
Copyright © 2019 VARO
P a g e
|
14
www.varo.com
WARNING! Never use a high-pressure washer or running water when
cleaning the shredder! Brush away dirt and plant residue which may be
caught in the spiral cutter. Wipe clean the outside of the shredder with a
cloth which has been moistened with a mild detergent and water.
13 STORAGE
To protect the shredder from corrosion when storing for a longer period, treat the cutting blade
with environmentally-friendly oil.
14 TROUBLE SHOOTING
PROBLEM
CAUSE
ACTION
The motor does not
run
Collection box not inserted
correctly /- safety handle not
moved up to close safety switch
Place collect box under machine and
close safety switch by pushing safety
handle upwards.
Power failure
Check the power supply cable, the
plug and the house fuse.
Overload protection is activated
Wait until the machine cools down
and press the green button.
Motor makes sound
but does not
function
Cutting roller is blocked
Turn off the device. Switch the
forward/reverse switch into reverse
directiona and switch on the machine
until the jam has been cleared.
Switch the machine off again and
turn back to forward rotation.
Capacitor fault
Bring machine to authorised service
center for repairing.
The material to be
chopped is not
drawn in
The cutting blade is running
backwards.
Switch over the direction of rotation.
The material is jammed in the
feeding funnel
Switch the shredder OFF.
Pull the material from the feed
funnel. Switch the shredder back ON
and re-feed thick branches such that
the blade does not immediately
engage the pre-cut notches again.
Shredding material is too soft
Insert wood or shred dried branches
The cutting blade is blocked.
Press the rotational switch in the
reverse position. The cutting blade
will now run backwards to release
the blocked up material.
Note : If blocked material is still not
released, you can enlarge the
distance between anvil and drum
knife.
Cutting roller worn
Readjust the anvil / drum knife
distance.
If the cutting roller is severely worn,
replace it.
Shredding material
comes out in chains
Anvil is incorrectly adjusted
Readjust the anvil / drum knife
distance
