POWXG5025
EN
Copyright © 2013 VARO
P a g e
|
7
www.varo.com
8 OPERATION
8.1
Fuel mixture
Gasoline liters
1
2
3
4
5
2-cycle oil ml
20
40
60
80
100
When preparing the mixture, only use oil for 2-stroke engines. Shake the fuel canister before
filling. Refill when the engine is switched off and faraway from naked flames. Before
unscrewing the fuel tank cap, position the power drill on a flat, solid surface.
8.2
To start a cold engine (Fig 3)
Place the engine switch to the on “1“ position.
PRIME - press the primer bulb 10 times slowly.
SET the choke lever to the “START’ position.
Lock on the throttle by pulling the throttle trigger and pressing in the lock button.
PULL the starter rope with a quick firm and consistent upwards motion until the engine
fires or starts and runs.
If the engine fires (pops) but does not continue to run, move the choke lever back to the
“RUN” position and continue to start the engine.
If the engine starts and runs, pull the throttle trigger to release It from the half-throttle
position and move to ch
oke lever to the “RUN” position.
Allow the engine to warm up for 5-20 seconds.
8.3
To start a warm engine
With the engine switch on “I" position PULL the starter rope with a quick firm and
consistent upward motion until the engine starts.
NOTE: Do not use the choke when starting a hot engine.
8.4
To stop the engine (Fig 4)
Press the engine switch to the stop “O” position. Wait until the engine stops.
8.5
Operating the earth auger (Fig 5)
Grip the power drill firmly with both hands and keep all parts of the body away from the auger
bit and muffler.
Hold the earth auger in front of you with the right hand firmly gripping on the throttle
handle and your left hand firmly gripping the other.
Always keep a firm grip with both hands while in operation.
The earth auger should be held at a comfortable position with the handle height no higher
than waist level.
The throttle trigger helps control the speed of the auger to suit various ground conditions.
Keep a comfortable distance between yourself and the drill without overreaching.
Always pay full attention to your operation. Serious injuries may result if contact is made
with the rotating auger.
NOTE: Your earth auger is supplied with a 300mm extension shaft to be
used for deeper hole digging. DO NOT start digging a hole with the
extension attached.
The hole should always be started with the auger bit only fitted.
Once the hole is deep enough and the operator handles are at least 300mm below waist level,
you may stop the unit and attach the extension shaft between the power head and the auger
for added comfort and deeper hole depth.
