POWXG3016
EN
Copyright © 2015 VARO
P a g e
|
8
www.varo.com
WARNING: 2-cycle lubricant must be a premium grade oil for 2-cycle air
cooled engines mixed at a 40:1 ratio. Do not use any 2-cycle oil product with a
recommended mixing ratio of 100:1. If insufficient lubrication is the cause of
engine
damage, it voids the manufacturer’s engine warranty.
9.2
Mixing fuel
Add oil to an approved fuel container followed by the petrol to allow incoming petrol to mix with
oil. Shake container to ensure thorough mix.
WARNING: Lack of lubrication voids engine warranty. Petrol and oil must be
mixed at 40:1.
9.2.1
Fuel and lubrication symbols
9.2.2
Recommended fuels
Some conventional kinds of petrol are now blended with oxygenates such as alcohol or an
ether compound to meet clean air standards. The engine is designed to operate satisfactorily
with any petrol intended for automotive use including oxygenated petrol.
10 OPERATING INSTRUCTIONS
10.1
Harness
Warning: always wear shoulder harness when operating unit with a blade.
Attach harness to trimmer after starting unit and engine is running at idle.
Turn engine off before disconnecting shoulder harness.
Adjust length of shoulder strap so stringhead is parallel to the ground as it hangs from the
strap. A few practice swings without starting engine should be made to determine correct
balance.
NOTE: Detach the shoulder harness from the unit before starting engine.
10.2
Starting a cold engine
Move the stop switch to “1”position.
Give a gentle push on the primer pump repeatedly (7-10 times) until fuel comes into the
primer pump.
Pull choke lever up to close choke.
Pull starter handle until engine flash fires.
