POWXG3016
EN
Copyright © 2015 VARO
P a g e
|
7
www.varo.com
8 ASSEMBLY
8.1
Bike handle installation (Fig. 1)
Install the U-handle on the fixing holder, install the clamp and fasten with the screws.
8.2
Installation protection guard (Fig. 2)
Remove the 2 screws from the guard.
Position the guard so it can be fixed into place with the clamp and the screws.
Tighten the screws.
8.3
Installing the harness (Fig. 3)
Adjust the harness hanger in a comfortable position.
Buckle the harness at the hanger.
8.4
Replace the metal blade to spool
CAUTION: NEVER use unit if blade is warped or has teeth that are chipped or
missing. Replace a damaged blade immediately.
CAUTION: Always wear heavy-duty work gloves when handling and installing
a blade.
8.4.1
Disassembly metal blade
Align the hole on the gear box to the slot on the flange washer
Use the pin to go through the hole and slot, and hold the flange washer
Loose the nut and remove the metal blade and cup washer
8.4.2
Assembly spool (Fig. 4)
Install the flange washer and cup washer on the spindle shaft.
Install the spool and tighten it.
STOP ENGINE IMMEDIATELY!
Excessive vibration of blade means that it is not properly installed-stop
engine immediately and check blade. Blade not properly installed will cause
injury.
9 FUEL AND LUBRICATION
9.1
Fuel
Use regular grade unleaded petrol mixed with 40:1 custom 2-cycle engine oil for best results.
Use mixing ratios in Section FUEL MIXING TABLE below.
WARNING: Never use normal petrol in your unit. This will cause permanent
engine damage and void the manufacturer’s warranty for the product. Never
use a fuel mixture that has been stored for over 90 days.
