POWXG1045
EN
Copyright © 2022 VARO
P a g e
|
7
www.varo.com
✓
Immediately rinse with water. Neutralize with a mild acid such as lemon
juice or vinegar.
✓
In case of eye contact, rinse abundantly with clean water for at least 10
minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do not
incinerate the battery.
7.2
Chargers
▪
Never attempt to charge non-rechargeable batteries.
▪
Have defective cords replaced immediately.
▪
Do not expose to water.
▪
Do not open the charger.
▪
Do not probe the charger.
▪
The charger is intended for indoor use only.
8 CHARGING AND INSERTION OR REMOVAL OF BATTERY
8.1
Charger indications (Fig. B)
Charger indicator LED
’s (11) :
▪
Solid red: charging
▪
Solid green: charged
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery pack
that does not securely fit the charger.
▪
Frequently monitor the charger and battery pack while connected
▪
Unplug the charger and disconnect it from the battery pack when finished.
▪
Allow the battery pack to cool completely before using it.
▪
Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
WARNING: Before making any adjustments ensure the tool is switched off or
remove the battery pack.
8.2
Charging the battery (Fig. B & C)
▪
Connect the power adapter (11) to a power outlet socket.
▪
Put the charger (10) on a flat surface and connect it to the power adapter.
▪
When inserting the battery pack (9) in the charger you have to make sure the negative
pole (A), corresponds to the negative pole (A) of the charger (10). The battery pack will not
fit in the charger if this is not correct.
▪
Push the battery pack in to the charger, the red LED (12) will light up.
▪
The green LED (12) will light up when the battery pack is fully charged.
▪
The battery can simply be pulled out of the charger.
8.3
Removal / insertion of battery (Fig. A & C)
▪
Hold the tool with one hand and the battery pack (9) with the other.
