POWX410
EN
Copyright © 2021 VARO NV
P a g e
|
7
www.varo.com
Connect air hose to item to be inflated and use included adaptors if needed.
Move the handle in the air hose down to lock adaptor in place.
Turn on air compressor unit via the switch located on the front of the Power Station.
Hold the air hose in place and monitor the air pressure gauge on the air compressor unit
for desired air pressure, once the desired air pressure is achieved turn off the air
compressor unit via the switch located on the front of the unit.
Disconnect the air hose from the item that has been inflated.
Store the Power Station in a safe place.
8.3
Your power station as a power source
To use the Power Station as a power converter, connect booster cable outputs to the positive
and negative terminals of your car battery. The power from this battery is then transferred to
the Power Station outputs. Thus you can use the power from this external battery rather than
from your Power Station.
USED AS POWER SUPPLY FOR THREE 12V DC APPLIANCES
You can use three 12V out lets at the same time.
Connect your appliances to the outputs.
NOTE: Do not attempt to jump start your car when you have 12 volt DC
outlets in use.
8.4
Emergency light
The built-in trouble light is turned on by the switch on the front of the unit.
8.5
Main unit fuse replacement
This unit requires the use of a 15 amp automotive fuse. To check the fuse :
Removes the fuse from the front of the unit.
Check the filament, if it is open replace with the spare fuse provided with your unit.
Press the fuse into the fuse holder until it is tight.
9 TECHNICAL DATA
Peak/start power
900 Amp
Compressor
250 PSI / 17 Bar
Weight
5.2 kg
Exits
3x12 V (with overload protection)
