POWX230
EN
Copyright © 2021 VARO
P a g e
|
7
www.varo.com
8.4
Performing straight and angle cuts
8.4.1
Straight cuts
Place the guide at the desired cutting distance.
Push the tile forward. Don't push to hard and let the disc do the job.
8.4.2
Angle cuts
1 ANGLE CUTS AT 45°
Use the supplied adjustable metal angle guide to cut a tile at 45°.
Place 1 corner of the tile in the angle guide, hold the tile firmly in its position, then Push
the tile forward. Don't push to hard and let the disc do the job.
2 FREE ANGLE CUTS
Use the supplied adjustable angle cutting guide. Set the angle as desired. Place and hold
the tile firmly in its position then push the tile forward. Don't push to hard and let the disc
do the job.
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2
Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and
regular cleaning.
10 TECHNICAL DATA
Rated Voltage AC (Un)
230V~
Rated Frequency (fn)
50Hz
Rated Power (Pn)
750W (S2
– 10min)
Rotation Speed (n)
2800 min
-1
Blade Size
Ø 180 x 22.2 x 2.2 mm
Disc Diameter
180 mm
Max. Cutting depth
34mm
Cable Length
1,75m
Maximum Cutting Capacity 90° - 0°
34mm
Maximum Cutting Capacity 45° - 0°
22mm
table size
420mm x 380mm
Protection Class
Class I