POWX1331LI
EN
Copyright © 2017 VARO
P a g e
|
8
www.varo.com
This ensures good adhesion and prevents premature wear.
▪
If the point has become worn, pull off the sand paper, turn it through 120º and place it on
again, or change the sanding paper.
9 OPERATION
9.1
Charging the battery pack (Fig. 4)
a.
Plug
b.
Charging socket
c.
Adapter
d.
Power indicator
The battery pack has been shipped in a low charge condition to prevent possible problem. You
should charge them prior to use.
Note:
Batteries will not reach full charge the first time they are charged. Allow several cycles
(drilling followed by recharging) for the item to fully charge. The battery should only be used
indoors.
The battery as supplied is not fully charged. Therefore, let the tool charge initially for 7 hours.
After the initial Charge, under normal usage, your tool should be fully charged in 1 to 1,5 hours.
The battery pack will become slightly warm to the touch while charging, this is normal and
does not indicate a problem.
Do not place the charger in an area of extreme heat or cold, it will best at normal room
temperature.
Charging indication:
The adapter (c) has one LED light. (See
Fig. 4)
1.
Plug the adapter (c) into suitable power outlet socket. The power indicator (d) will light
green once the connection has successfully completed.
2.
Plug the charger plug (a) into the charging socket (b) of battery pack (6) and ensure to
connect firmly. The power indicator (d) will be changed to red which on the adapter (c)
that means the battery pack is charging.
3.
When the battery is loaded, the power indicator (c) change from red to green until the
charger disconnect from the mains.
NOTE:
If the battery does not fit properly, disconnect it and confirm that the battery pack is the
correct model for this charger as shown on the specification chart.
Do not charge any other battery pack or any battery pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected.
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE:
If battery is hot after continuous use in the tool, allow it to cool down to room
temperature before charging. This will extend the life of your batteries.
9.2
Removal / insertion of battery
WARNING:
Before making any adjustments ensure the multi-use tool is switched off.
1
Hold the multi-use tool with one hand and the battery pack (6) with the other.
2
To install:
pull and slide battery pack into battery port, make sure the latch (5) on the
both side of the battery snap into place and battery is secure before begging operation.
3
To remove:
use your thumb and fingers, press the battery release latches in and pull
the battery pack off at the same time.
9.3
Speed adjusting (Fig. 3)
The tool can be set at 6-speed adjustment positions. The "1" position indicates the lowest and
the "6" position indicates the highest speed, you can adjust different speed by turning the
speed control dial (8) from "1" to "6" position. The operator may have to vary the speed to
optimize working efficiency.
