POWX0760
EN
Copyright © 2014 VARO NV
P a g e
|
11
www.varo.com
8.3
Adjusting the Mitre angle (Fig. 9 & 10)
Loosen the clamping screw on the guide fence by turning counterclockwise. Turn the turn
table by handle. When you have moved the handle to the position where the pointer points to
the desired angle on the Mitre scale, securely tighten the clamping screw clockwise.
CAUTION:
When turning the turn table, be sure to raise the handle fully.
After changing the Mitre angle, always secure the turn table by tightening the clamping
screw firmly.
8.4
Adjusting the bevel angle (Fig. 11 & 12)
8.4.1
In the Mitre saw mode
To adjust the bevel angle, loosen the lever at the rear of the tool counterclockwise. Push the
handle to the left to tilt the saw blade until the pointer points to the desired angle on the bevel
scale. Then tighten the lever clockwise firmly to secure the arm.
CAUTION:
When tilting the saw blade, be sure to raise the handle fully.
After changing the bevel angle, always secure the arm by tightening the lever clockwise.
8.4.2
In the table saw mode (Fig. 13)
To adjust the bevel angle, loosen the lever under the table at the front of the tool
counterclockwise. Move the depth adjusting knob to the left to tilt the saw blade until the
pointer points to the desired angle on the bevel scale. Then tighten the lever clockwise firmly
to secure the arm.
8.5
Switch action (Fig. 14)
8.5.1
Switch for the table saw mode (B)
CAUTION:
Before operation, make sure that the tool is turned on and off.
To start the tool, press the ON ( I ) button. To stop it, press the OFF (O) button.
8.6
Adjusting the depth of cut (Fig. 15 - 21)
( In the table saw mode )
The depth of cut can be adjusted by turning the cutting depth adjusting knob. Turn the cutting
depth adjusting knob clockwise to raise the blade or counterclockwise to lower it.
WARNING: Use a shallow depth setting when cutting thin materials in order
to obtain a cleaner cut.
CAUTION:
The stopper pin cannot be turned with the tool head at fully lowered position. At this time,
turn the knob counterclockwise slightly and the stopper pin can be released. (Fig. 16)
9 ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and unplugged before carrying out any work on
the tool.
9.1
Socket wrench storage (Fig. 17)
The socket wrench is stored as shown in the figure. When using the socket wrench, pull it out
of the wrench holder. After using the socket wrench, return it to the wrench holder.
