POWX0077LI
EN
Copyright © 2013 VARO
P a g e
|
6
www.varo.com
Do not cut nails or screws unless you are using a blade specifically designed for this
purpose. Inspect your material before cutting
Before switching on the tool, be sure the blade in not contacting the work piece.
Keep hands away from moving parts and on the top surface of the work piece. Do not
place hands below work surface while saw is operating.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND
CHARGERS
7.1
Batteries
Never attempt to open for any reason.
Do not store in locations where the temperature may exceed 40 °C.
Charge only at ambient temperatures between 4 °C and 40 °C.
Charge only using the charger provided with the tool.
When disposing of batteries,
follow the instructions given in the section “Protecting the
environment”.
Do not cause short circuits. If connection is made between the positive (+) and negative (-)
terminal directly or via accidental contact with metallic objects, the battery is short circuited
and an intense current will flow causing heat generation which may lead to casing rupture
or fire.
Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
Carefully wipe the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions below:
Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.
In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
7.2
Chargers
Use the charger provided with the tool only to charge the battery
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
8 ASSEMBLY
8.1
Install or remove the saw blade (Fig 1)
Rotate the Quick-release blade clamp (2) anticlockwise with hand.
At the same time push blade (7) to the deepest position, then release the quick-release
blade clamp (2). Make sure it is securely fastened.
When removing the saw blade (7), follow the above procedure in reverse order.
