POWE60015
EN
Copyright © 2017 VARO
P a g e
|
6
www.varo.com
Turn the tub upright again.
Re-fit the motor housing.
7.2
Mounting the hose
Insert the hose (8) in the connection (6) and press it on firmly.
7.3
Fitting and removing the motor housing
The motor housing has been locked to the tub with clamps.
To remove the motor housing (3). First remove the clamps (6) and then lift it from the tub
(7).
To re-fit the motor housing, place it on the tub and tighten the damps.
7.4
Fitting the dust bag
A dust bag is suitable for collecting small waste material and dust.
Remove the motor housing (3).
Suspend the dust bag in the tub.
Re-fit the motor housing.
7.5
Mounting the tube to the hose
Slide the tube on the handgrip (9).
Place the required nozzle on the tail end of the tube.
8 OPERATION
Make sure the power cord has been fully unwound before you switch on the machine. The air
leaving the grids must not be hindered.
When using the machine in combination with an electrical tool, switch on the machine first and
then the electrical tool.
8.1
Switching on and off
To switch the machine on, set the on/off switch (1) to “I”.
To switch the machine off, set the on/off switch (1) to "0".
8.2
Vacuuming up waste material
Check whether the dust bag (14) has been fitted.
Mount the universal nozzle (11) to the tube (10).
8.3
Vacuuming up dust released from an electrical tool
Check whether the dust bag (14) has been fitted.
Connect the hose with the handgrip (9) directly to the dust extraction outlet of the electrical
tool.
8.4
Vacuuming up liquids
Check whether the dust bag (14) has been removed.
Make sure the inside of the tub (7) is clean and free from dust.
Mount the tube (10) to the handgrip of the hose (9). Leave an opening at the top of the
universal nozzle in order to enable the air flow.
8.5
Blowing
You can also use this tool to blow away dust, leaves etc. Disconnect the hose from the
hose connection (6) on the side of the tub and connect the hose to the special connection
for the blow function (16) on top of the tool.
8.6
Emptying the tub
Switch off and unplug the machine.
Remove the motor housing (3).
Empty the tub (7).
