POWE10081
EN
Copyright © 2018 VARO NV
P a g e
|
6
www.varo.com
8 OPERATION
8.1
Switching ON/OFF
▪
Connect the plug to the power supply. The power-on indicator (11) is illumed until the tool
disconnect from the power mains.
▪
Switching on:
Press the operating switch (7).
▪
Switching off:
Release the operating switch (7)
8.2
Handle attachment (Fig. 3)
For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the handle attachment.
Loosen and turn the handle attachment in an ant-clockwise direction. Slip loop onto the neck
of the housing tool and position the handle, then tighten the handle attachment.
8.3
Depth stop
Loosen the handle attachment and place the straight part of the depth stop in the hole. Adjust
the depth stop and retighten the handle attachment.
8.4
Dust collection device (Fig. 4)
Before carrying out hammer-drilling work vertically overhead pull dust collecting device over
the drill bit.
8.5
Hammer / drill switch
▪
The hammer/drill switch can switch the drill, hammer and hammer/ drill functions.
▪
To set the function, please use below compounding of front and rear hammer/drill switch.
Hammer/ drill mode:
Drill in masonry, concrete and natural stone.
Don’t use the hammer drill function for ceramic
tile or others material can not withstand impact
energy.
Hammer mode:
Drill in masonry, concrete and natural stone.
Drilling mode:
Drilling in wood, synthetic materials and metal.
Chisel Rotation:
Non-working position used only to rotate flat
chisel into the desired position
WARNING! No function mode:
The motor turns without load,
the shaft will not turn. Do not
set the switch like this. It may
damage the motor greatly.
