POWDP25100
EN
Copyright © 2021 VARO
P a g e
|
8
www.varo.com
▪
To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3
Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (12). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LE
D’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
9 ASSEMBLY
9.1
Install or remove the saw blade (Fig 4)
WARNING: Before making any adjustments ensure the saw is switched off
with the lock-off button in the centre position and remove the battery from
the saw.
▪
Rotate the Quick-release blade clamp (2) anticlockwise with hand.
▪
At the same time push blade (8) to the deepest position, then release the quick-release
blade clamp (2). Make sure it is securely fastened.
▪
When removing the saw blade (8), follow the above procedure in reverse order.
WARNING! Before plugging in battery pack, always pull on the blade to
make sure it is securely locked in the clamp. Failure to do so may result in
serious injury.
10 OPERATION
10.1
Switch on/off (Fig. 5)
▪
Make sure the battery pack is installed.
▪
Push the lock-off button (5) towards left or right and squeeze the ON/OFF switch trigger
(6).
▪
To switch off simply release the ON/OFF switch trigger (6).
10.2
To change angle of the pivot shoe assembly (Fig. 6)
The pivot shoe assembly can be adjusted in a suitable angle by hand which is convenient for
operating this tool.
10.3
To change position of the pivot shoe assembly (Fig 7)
▪
Pull-open the quick-change lever (4) to the max. angle, pull or push the shoe (1) to a
desired position.
▪
Push-back the lever to lock it, pull or push the shoe to ensure it is immovable.
WARNING: Cutting into electrical wiring in walls can cause blade, blade
clamp, and saw bar assembly to become electrically live. Do not touch
metal parts when cutting into a wall; grasp only the insulated gripping
surfaces provided by the tool. Make sure hidden electrical wiring, water
pipes, and mechanical hazards are not in the blade path when cutting into a
wall.
