POWDP1570
EN
Copyright © 2018 VARO
P a g e
|
10
www.varo.com
Important! Hammer drilling requires a low pressure. Too much pressure will
place unnecessary load on the motor. Check the drill bits regularly. Re-
sharpen or replace blunt drill bits.
Do not use the chuck with SDS connector in combination with the
hammer/hammer drill function!
9.11
LED light (Fig. 7)
The LED work-light can light prior to motor running if you press the switch lightly, which keep
the work area to be lighted for checking clearly at first, and it lights also during your operation.
WARNING: Do not stare directly at the light beam. Never aim the beam at
any person or an object other than the work piece.
Do not deliberately aim the beam at personnel and ensure that it is not
directed towards the eye of a person for longer than 0.25 s.
10 CLEANING AND MAINTENANCE
10.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
10.2
Maintenance
▪
Our machines have been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper machine care
and regular cleaning.
11 TECHNICAL DETAILS
Rated voltage
40 V
Rotation speed
0-1100 min
-1
Drill capacity concrete
26 mm
Drill capacity steel
13 mm
Drill capacity wood
30 mm
Impact rate
0-5100 min
-1
Drilling mode:
Drilling in wood, synthetic materials and metal.
Chisel Rotation:
Non-working position used only to rotate flat chisel into the desired position
