POWC10200
EN
Copyright © 2021 VARO
P a g e
|
5
www.varo.com
7.3
Depth gauge
The depth stop is used to limited the maximum drilling depth.
▪
Loosen the side grip (8).
▪
Insert the depth stop (2) in the hole in the holder of the side grip.
▪
Adjust the depth stop to the required drilling depth.
▪
Tighten the side grip firmly.
8 OPERATION
8.1
Selecting the operation mode
Select the required operating mode before use (drilling or hammer drilling).
▪
For drilling in wood, metal, plastics and soft stone, push the switch (3) to the drill position.
▪
For drilling in concrete or hard stone, push the switch (3) to the hammer position.
8.2
Forward / reverse lever
▪
To select forward position (right rotation), push the forward / reverse lever to the right (R).
▪
To select the reverse position (left rotation), push the forward / reverse lever to the left (L).
8.3
Variable speed
This tool has a speed control dial (6) that delive
rs higher speed by turning to the “+” position
and delivers lower speed by turning to the “-“ position.
8.4
Switching ON and OFF
Connect the tool to the power supply.
To start the machine, you squeeze the ON / OFF switch (4).
To stop the machine, you release the ON / OFF switch.
8.5
Continuous mode
To switch the machine to continuous mode, keep the on/off switch pressed and at the same
time press the lock-on button (5). Subsequently release the on/off switch.
To switch off continuous mode, press the on/off switch again.
Never put down the machine when using the continuous mode!
9 CLEANING AND MAINTENANCE
Before performing any work on the equipment, pull the power plug.
9.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
9.2
Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and
regular cleaning.
