POWXG8020LI
EN
Copyright © 2014 VARO
P a g e
|
7
www.varo.com
7.3
Charging
Attention! Only use battery charger in dry places.
Before first use, the battery needs to be charged for about 1,2 hours. Use only the original
charger.
Remove the battery from the device .
Insert the battery into the charger .
Connect the charger to the mains voltage (LED lights up green).
7.3.1
Notes on charger :
LED 10 lights up red: Battery is charging
LED 11 lights up green: Charging completed
LED 10 blinks red: Fault (e.g., battery is too hot)
Self-discharge of batteries! Remove the battery from the charger once it is
fully charged.
7.4
General instructions:
Regarding the battery, in order to maintain the long service life of the battery, always follow the
instructions below:
The tool will automatically be switched off when the battery voltage is low. The battery
must then be recharged before the tool can be used again.
Always recharge the lithium-ion battery prior to any prolonged period of non-use, i.e. before
storing the tool away in autumn.
The charging time is 1,2 hours for a battery that is completely empty.
The lithium-ion rechargeable battery can be charged at any charge level and charging can
be interrupted at any time without damaging the battery (no memory effect)
8 OPERATION
8.1
Switching on:
Press and hold the safety switch on the front grip (3).
And press the on/off button (4) at the same time.
8.2
Switching off:
Release one of the two buttons.
8.3
Cutting hedges
A trapezoidal cut corresponds to the natural, growth of plants and results in optimal hedge
growing.
In order to promote thick growth of young hedges, only half of new shoots should be cut.
If the hedge has already reached the desired height, new shoots can be completely
removed.
First cut the sides from the bottom to the top. Cut the upper part giving it the shape you
prefer, in a straight horizontal form, roof-like or rounded.
If the blades are jammed or blocked by obstacles, switch the motor off immediately,
remove the battery, and then remove the object jamming the blades.
Caution! Metal obstacles like fences etc. may damaged the cutting blades.