POWXG30030
EN
Copyright © 2015 VARO
P a g e
|
8
www.varo.com
10 INTELLIGENT LINE FEED
When initially switching on the trimmer, a small length of line is fed out.
A ‘clattering’ noise will be heard when the lines hit the line cutter. DO NOT BE ALARMED this
is quite normal. After about 5 seconds the line will be cut to the correct length and the noise
will reduce as the motor receives full speed.
If the noise of the line being cut can’t be heard, more line will be fed out.
This trimmer has an intelligent line feed, so the spool will automatically feed more line when
needed, and when the line is subjected to some resistance.
No need to stop machine, as this system will act itself.
Make sure that line is fed out before operation. Make sure motor is up to full speed before
trimming.
Use only 1.40mm diameter cutting line. Other sizes of line will not feed properly and will result
in improper cutting head function or can cause serious injury. Do not use other material such
as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile
that can cause serious injury.
11 TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Line will not
advance
Line is welded to itself
Not enough line on the spool
Line has worn too short
Line is tangled on the spool
Lubricate with a silicone
spray
Replace the spool
Remove the spool and feed
line out
Remove line from spool and
rewind
Cutting head is
hard to turn
Grass wrapped or built up
around head
Clean the effected parts of
the machine
Grass continually
wraps around
the shaft and
trimmer head
assembly
Cutting tall grass at ground
level
Cut tall grass from the top
down
Line trimmer
stops and will not
start again
Unit failed
Plug is damaged
Contact dealer to check
damage
Check the plug
