POWXG1032
EN
Copyright © 2016 VARO
P a g e
|
8
www.varo.com
The power saw is likely to recoil if the tip of the guide bar (especially the top quarter)
accidentally touches wood or any other solid objects. In this case the saw will move
uncontrolled and will be hurled towards the operator at full power (risk of injury!).
When working with the chain saw, protective gloves, suitable shoes, leg protectors, eye
protectors and ear protectors should be used.
If the work involves any risk of head injury, a safety helmet must be worn When cutting
down trees and cutting off branches of felled or fallen trees. in addition a face protector
should be worn.
Always pull the plug from the socket outlet before attempting to check or adjust the chain
or to correct some fault and whenever moving one workplace to another.
Never switch on the chain saw unless you have a firm hold of the tool. a secure footing
and are sure that the guide bar and saw chain are not touching anything.
Always hold the saw with both hands (right hand on rear handle, left hand on handle.
Never saw above shoulder height, while standing on a ladder or In a tree or in any other
insecure position.
When sawing timber that has split, take particular care that no small pieces of wood are
broken off and thrown by the saw chain.
During breaks, the saw should be laid down in such a way that there Is no risk of injury to
anyone from the saw chain.
The chain saw should never be lent to or be allowed to come into the hands of persons
who are not familiar with the use of such a tool. The operating Instructions should also go
with the saw.
7 KICKBACK
In order to prevent kick-back, please follow these safety instructions:
Never start cutting with the tip of the guide bar!
Never cut with the tip of the guide bar! Be careful, when continuing cuts you are already
working on!
Always start cuts with the chainsaw already running!
Make sure that the saw chain is always properly sharpened.
Never cut through more than one branch at a time! When lopping off branches, be careful
not to touch any other branches.
When cross-cutting, pay attention to trunks standing very close to each other. If possible
use a saw-horse.
8 TRANSPORTING THE CHAINSAW
Before transporting the chainsaw, always remove the plug from the power socket and slide the
chain guard over the rail and chain. If several cuts are to be performed with the chain saw, the
saw must be switched off between cuts.
9 BEFORE STARTING UP
The voltage and current supply must comply with the ratings on the type plate.
Before commencing work, always check that the chainsaw works properly and is safe to
operate.
Check also that the chain lubrication and the oil gauge are in good working order. When
the oil lever is approx. 5 mm from the bottom mark, you must top up with oil. When the oil
level is higher you can work without worry.
Switch on the chain saw and hold it above the ground. Be careful not allow the chainsaw
to touch the ground. For safety reasons it is best to keep a clearance of at least 20 cm. If
you now see growing traces of oil, the chain lubrication system is working correctly. If
there are no traces of oil at all, try cleaning the oil outlet, the upper chain tensioning
borehole and the oil duct, or contact your Customer Service. (Be sure to read the section
“Filling in chain oil and chain lubrication” on this point).
