POWAIR0803
EN
Copyright © 2014 VARO
P a g e
|
5
www.varo.com
Proper adjustment of the in-line lubricator is performed by placing a sheet of paper next to
the exhaust ports and holding the throttle open approximately 30 seconds. The lubricator
is properly set when a light stain of oil collects on the paper. Excessive amounts of oil
should be avoided.
In the event that it becomes necessary to store the tool for an extended period of time
(overnight, weekend, etc.), it should receive a generous amount of lubrication at that time.
The tool should be run for approximately 30 seconds to ensure oil has been evenly
distributed throughout the tool. The tool should be stored in a clean and dry environment.
It is most important that the tool be properly lubricated by keeping the air line lubricator
filled and correctly adjusted. Without proper lubrication the tool will not work properly
and parts will wear prematurely.
Use the proper lubricant in the air line lubricator. The lubricator should be of low air flow
or changing air flow type, and should be kept filled to the correct level. Use only
recommended lubricants, specially made for pneumatic applications. Substitutes may
harm the rubber compounds in the tools, O-rings and other rubber parts.
8
IMPORTANT!!!
If a filter/regulator/lubricator is not installed on the air system, air operated tools should be
lubricated at least once a day or after 2 hours work with 2 to 6 drops of oil, depending on
the work environment, directly through the male fitting in the tool housing. Fig. 1
1.
Tool
2.
Quick connector
3.
Quick coupler
4.
Air hose
5.
Quick connector
6.
Quick coupler
7.
Lubricator
8.
Regulator (0-8.5 bar)
9.
Filter
10.
Cut-off valve
11.
Air compressor
9
LOADING AND OPERATION
WARNING: Ensure you read, understand and apply safety instructions
before use.
1.
Connect the tool to the air hose.
2.
Press the trigger to operate the tool.
3.
The flow of air may be regulated by adjusting flow valve at the base of the handle.
4.
Ensure the air supply is clean and does not exceed 90psi while operating the tool.
Too high an air pressure and unclean air will shorten the product life due to
excessive wear, and may be dangerous causing damage or personal injury.
DO NOT use any additional force upon the wrench in order to remove a
nut.
DO NOT allow wrench to free run for an extended period of time as this
will shorten its life.
