POWX07590
EN
Copyright © 2019 VARO
P a g e
|
12
www.varo.com
▪
Push the workpiece evenly towards the back and saw in a single process. Make sure that
the saw Is not overloaded.
▪
Use the red button 0 on the On / Off switch (1) to switch the unit off if you are not going to
continue working immediately.
9.7
Dust extraction connection
The dust extraction connection (5) is located at the rear of the saw. A dust collection system
can be attached to this port to aid the removal of sawdust from the work area.
10 CLEANING AND MAINTENANCE
10.1
Cleaning and maintenance overview
Prior to each use
What?
How?
Check the saw blade to ensure it is
correctly positioned and fixed in place.
Changing the saw blade
Check the saw blade protector box for wood
chippings/saw dust Remove chippings if
necessary.
Use compressed air to blast the
chippings/dust out or use a brush.
Check that the gap between the saw blade
and the cleaving wedge is set to 3 to 5 mm;
correct if necessary.
Adjusting the cleaving wedge
Check the connection cable for any signs of
damage
Conduct a visual inspection and have the
cable replaced by an electrician if
necessary.
Regularly and according to operating conditions
What?
How?
Screw connections
Check all screw connections and tighten if
necessary.
Clean the ventilation slots on the motor to
remove dust
Use a vacuum or a brush to remove the
chippings/dust.
10.2
Cleaning the device
Risk of electric shock! Never splash with water or expose to water. Never
use detergents or solvents to clean. These may cause irreparable damage
to the unit The plastic pieces may be corroded by the chemicals.
Careful treatment and regular cleaning will ensure that the unit remains functional and
performs well for a long time.
▪
Remove dirt with a brush.
▪
Wipe the tool with a damp cloth.
▪
Keep ventilation slots clean and free of dust
10.3
Unit maintenance
Risk of injury! Before conducting any maintenance work make sure the
device is unplugged (disconnect the power supply).
Risk of injury! Shortly after sawing, the saw blade may be very hot. Allow a
hot blade to cool down. Never dean a hot saw blade with flammable liquids.
A still saw blade can cause injury! Use gloves to change the saw blade.
