POWX0041LI
EN
Copyright © 2018 VARO
P a g e
|
9
www.varo.com
8.4
General hints for drilling
8.4.1
Drilling in all materials
Always use sharp drill bits. Mark the place where you would like the hole to be drilled.
Commence with a slow speed to start the hole. Reduce your pressure on the drill when the drill
bit is about to break through the material.
8.4.2
Metal drilling
Support thin material with a piece of scrap wood. Use a center punch to mark the position of the
hole. If drilling a large hole, use a small size drill bit first to establish a pilot hole then use the
required large size drill bit. Use only HSS (High Speed Steel) drill bits or those recommended
for metal use. When drilling into iron or steel, use no lubricant but withdraw the drill regularly to
assist cooling.
8.4.3
Wood drilling
Mark the place where you want to drill with a punch or a nail. To avoid splintering on
breakthrough, either clamp a piece of scrap wood to the back of your work piece or continue the
hole from the back of the wood when the drill bit first breaks through.
9 MAINTENANCE
9.1
General
Your tool has been designed to operate over a long period of time with a minimum of
maintenance.
▪
Continuous satisfactory operation depends upon proper tool care and regular cleaning.
Clean your tool using a damp cloth.
▪
Your charger does not require any maintenance apart from regular cleaning, unplug it
before cleaning.
▪
Use a soft brush or dry cloth.
▪
KEEP VENTILATION SLOTS CLEAN! Periodically check the air vents for dust or other
debris. Clean with compressed air (max. 3 bar)
Do not use any abrasive or solvent-based cleaner. Use clean cloths to remove dirt, carbon dust,
etc.
WARNING: Do not allow brake fluids, gasoline, petroleum-based products, penetrating oils, etc.
come in contact with plastic parts, they contain chemicals that can damage, weaken or destroy
plastic.
WARNING: Always wear safety goggles or safety glasses with side shields when using
compressed air to clean tools. If the operation is dusty, also wear a dust mask.
BATTERIES: The battery pack for this tool is equipped with a Li-ion
rechargeable battery. Do not disassemble battery pack and attempt to
replace the batteries inside.
9.2
Service
Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
10 STORAGE
Store your tool in a clean, dry, frost free environment.
Battery storage
