POWXG9025
EN
Copyright © 2014 VARO
P a g e
|
6
www.varo.com
Check especially the insulation of the electric cable should be faultless and without any
cracks. If the electric cable is damaged, an authorized local service centre should replace
it.
WARNING: High pressure jets can be dangerous if subject to misuse. The
jet must not be directed at persons, live electrical equipment or the
appliance itself.
WARNING: Do not use the appliance within range of persons unless they
wear protective clothing.
Do not direct the jet against yourself or others in order to clean clothes or foot-wear.
Hold the spray lance firmly with both hands.
The operator and anyone in the immediate vicinity of the site of cleaning should take action
to protect them from being struck by debris dislodged during operation.
Wear goggles and protection clothes during operation.
Disconnect from electrical power supply before carrying out user maintenance.
To ensure appliance safety, use only original spare parts from the manufacturer or
approved by the manufacturer.
Do not use the appliance if a supply cord or important parts of appliance are damaged, e.g.
safety device, high pressure hose and trigger gun.
Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it
immediately. Do not put it in water.
Tires and tire valves may be damaged by the high-pressure jet and then burst.
Never use the machine in an environment where there could be a danger of explosion.
It is not allowed to clean asbestos- containing surfaces with high pressure.
This high pressure washer must not be used at temperatures below 0°C
WARNING: High pressure hoses, fittings and couplings are important for
the safety of the appliance. Use only hoses, fittings and couplings
recommended by the manufacturer.
WARNING: Inadequate extension cables can be dangerous. Cables on reels
should always be completely unwinded to prevent the cable from
overheating.
If an extension cable is used, the plug and the socket must be waterproof and comply with
the below-mentioned requirements for length and cable dimensions.
1.0 mm² max. 12.5 m
1.5 mm² max. 20 m
If the electric cable is damaged, it must be replaced by the manufacturer or his service
agent or similarly qualified person in order to avoid a hazard.
6.1
Mains power connection
The following should be observed when connecting the high pressure washer to the electric
installation:
The electric supply connection shall be made by a qualified electrician and comply with IEC
60364-1
It is recommended that the electric supply to this appliance should include either a residual
current device that will interrupt the supply if the leakage current to earth exceeds 30 mA
for 30 ms.
