Varmebaronen Vedolux 55, Руководство по установке и обслуживанию

Страница: 18 / 24

18 Värmebaronen Vedolux 55
3. Flue pipe.
4. Fan motor.
7. Soot hatch.
8. Bypass damper control.
9. Wood filling hatch.
10. Ash hatch.
19. Leg frame with ash drawer.
29. Tool for turbulators.
30. Turbulators, please note the position.
32. Plate at the front top of the combustion chamber.
33. Inner ash hatch with secondary air damper.
34. Ceramic grate, two parts, front and rear.
43. Protective grille for fan.
44. Collection chamber.
Sweeping
In a well-swept boiler, less heat accompanies the flue
gases out. A flue gas thermometer gives an indication
of when it is time to sweep. Sweeping is a good idea
when the temperature has risen by approximately 77°F
compared to a well-swept boiler.
All boiler sweeping takes place from its front.
The ash should be raked out of the ceramic tunnel
before each firing. Tar coating in the combustion
chamber is not normally a problem with correct firing
with an accumulator tank.
• Open the soot hatch.
• Pull out the turbulators with the turbulator tool.
Sweep the flues with the flue brush.
Be careful when sweeping the upper flues so that
the flue brush does not pass through the protective
grille and damage the fan. The flue brush must not be
inserted further than to the end of the flue. You can
tell when it has reached the end because less force is
required to move it.
Refit the turbulators.
• Open the wood filling hatch and bypass damper.
Rake out the ash on the plate in the top front of the
combustion chamber.
There should always be a small quantity of ash on the
ceramic grate to increase the service life of the grate.
• Open the ash hatch and remove the inner ash hatch.
Rake the ash out of the ceramic tunnel. Leave a layer
of a few centimetres. Clean the chamber around the
flame bowl. Close all hatches and dampers.
Sweeping the chimney
After sweeping the chimney, remove the wing nuts on
the front of the flue pipe and remove the cover. Remove
soot and ash. Remove any ash that has fallen down on
the fan and in the collection chamber before the boiler is
started again.
Cleaning the fan
When required, remove the fan and clean it. Handle the
fan with care.
• Disconnect the fan's connector from the outlet on the
boiler.
• Remove the long nuts that hold the fan in place.
• Clean the fan blades carefully, preferably with a brush.
• Refit the fan and connect the power cable.
3
4
7
8
9
10
44
43
34
33
32
30
29
19
When sweeping, no fire or residual embers may be
left on the grate.
Switch off the power to the boiler sweeping begins.
The ash may contain residual embers for a long time
after firing. Therefore, keep it in a non-combustible
container with a lid.