Varisco S.p.A.
Z.I. Nord - Terza Strada, 9 - 35129 PADOVA – ITALY
Tel.+39.049.8294111 Email: [email protected]
Fax+39.049.8076762 Web: www.variscospa.com
4
1.7 REPAIRING
The customer shall gather in advance detailed information on the pump, as illustrated in the
repairing instructions.
The service staff shall be trained and repairing work shall be monitored.
1.8 RISKS IN THE EVENT OF NON-COMPLIANCE WITH SAFETY WARNINGS
Non-compliance with safety warnings may put people, the environment and the machine itself at
risk.
In particular, for instance, non-compliance may lead to:
•
Failure to perform important functions by the machine/plant.
•
Malfunctioning of the methods prescribed for maintenance and repairing.
•
Risk vs. people due to electric, mechanical and chemical effects.
•
Environmental risks due to leakage of harzardous substances.
1.9 SAFE WORKING
It is necessary to observe the safety warnings set out in these instructions, the national rules on
accident prevention and possible regulations concerning the work, service and safety of the
operator.
1.10 WARNINGS CONCERNING THE SAFETY OF THE OPERATOR/USER
•
In the event that cold or hot parts of the machine may lead to risks, the customer must
provide protection against accidental contact (according to European regulation EN 563).
•
The protection against accidental contact on the moving parts (e.g. joint) may not be
removed when the machine is working.
•
Leakage of hazardous materials (e.g. from shaft seal) such as explosive, poisonous and
overheated materials, shall be disposed of without causing danger to both people and the
environment. Provisions of the law shall be compiled by.
1.11 WARNINGS CONCERNING SAFETY DURING MAINTENANCE, INSPECTION AND
ASSEMBLY
The customer shall make it sure that any maintenance, inspection and assembly operations are
carried out by authorized, specialized and qualified staff, and that said personnel must be adequately
informed by fully detailed service instructions.
The work on the machine shall be executed only when the machine is not working. The machine
shall not be under pressure and shall be cooled. The procedure for machine stop shall be absolutely
complied with.
Those pumps or units feeding hazardous materials shall be decontaminated.
After work is completed, every safety and protection devices shall be immediately refitted and
reactivated.
Before restarting, the provisions of the chapter Startup shall be compiled by.
1.12 TRANSFORMATION AND ARBITRARY PRODUCTION OF SPARE PARTS
Any transformation or modification of the machine is allowed only by prior agreement with the
manufacturer. Original spare parts and authorized accessories are required for safety. The use of
other parts releases any responsibility for related damages.
1.13 PROPER USE
The safety of the machine is guaranteed only when the use of the machine is carried out according
to the rules.
