Make sure the printer is located
near an accessible power outlet.
MAIN
TEST_PRINT.G
VASE.G
BRACELET.G
YOUR_PRINT.G
STARTING A PRINT
Insert your SD card into the slot to the left of the
screen. Use the dial to select Print on the main menu.
1
Scroll down to the file you want to print and push the
dial in to start the print.
2
Temp
MAIN
MENU
Status
Control
Wizard
Use a box cutter to
trim along the taped
edges and peel back
the outer box flaps.
The Trifecta™ 800 3D
Printer can be too heavy
to lift out of the box by
yourself. Ask for help to
prevent injury or damages
to the printer.
Open shipping box and remove the compartment lid.
1
Remove foam bracket and take out the printer and filament.
2
Remove printer accessories from the compartment.
3
SD Card
USB Cable
Power Cable
Print Bed Clips x4
Glass Print Bed
Hex Wrench
Trifecta™ 800 Printer
Filament Spool
Place the printer on a firm flat surface.
5
Remove the printer and filament from the box.
4
Place the Trifecta™ 800 3D Printer and PLA Filament
in a moisture-free and low dust environment.
Bed Leveling Tip! The on-screen instructions will guide you through leveling your bed at three different points. For
proper calibration, slide a piece of construction paper under the hotend at each of the three points. Tighten/loosen
the leveling screws to ensure a slight drag on the construction paper. Turn the screws clockwise to raise the bed
and counterclockwise to lower the bed.
Store opened spools of filament in a sealed bag with
a desiccant packet.
Whenever you begin a print, always check that the first layer of the print is properly stuck onto the blue painter’s tape. A
properly leveled bed should have the extruded filament a bit squished and shouldn’t pop off the bed easily. While the
printer is performing the skirt nozzle purge, observe the deposited filament and make micro-adjustments with the thumb-
screws if necessary.
TOO CLOSE
LEVELED
TOO FAR
lbs
36.4
Trifecta
800 3D Printer
™
TECHNICAL SUPPORT
For technical assistance, please contact your authorized VariQuest dealer or the VariQuest Technical Support team:
• Email: [email protected]
• Phone: 1-800-328-0585
© 2016 Varitronics®, LLC. All Rights Reserved.
R2900224 6/2016
Blue Tape
