Cutout Maker 1800
Unpacking and Setup Instructions
(Instructions Continued on Other Side)
Step 1. Unpack the Cutout Maker
The Cutout Maker and accessories are packed in a cardboard carton with foam
padding for protection during shipment.
Carefully unpack the items and keep
the packing materials. If you need to ship the Cutout Maker in the future,
repack the system as indicated below.
1. Remove the cardboard cover and packing foam.
2. Remove the front and rear endcaps.
3. Carefully remove the Cutout Maker from the foam cradle and shipping
container.
4. Open the Cutout Maker cover and remove the foam from the blade
assembly and gantry rail.
Note:
When repacking: 1) Position the blade assembly and gantry rail
foam pieces correctly so they make a snug fit. 2) Position the endcap
with the notch on the rear side of the gantry and the other endcap on
the front. 3) Position the packing foam so it is snug against the gantry
rail and without a gap.
Step 2. Verify the Package Contents
After unpacking, verify that all of the following items were included in the Cutout
Maker box. For additional information, refer to the
VariQuest
®
Cutout Maker
1800
User’s Guide located at
www.variquest.com
.
WARNING
Due to the weight of the unit, we recommend that 2 people lift the
Cutout Maker from the carton. To avoid personal injury, use proper
lifting techniques when removing the Cutout Maker from the carton.
CM1800
Foam
Shipping
Cradle
Container
Packing
Foam
Cardboard
Cover
End Cap
(rear, notch)
End Cap
(front)
Gantry Rail
Foam
Blade
Assembly
Foam
Electrical Power Cord
USB Cable
Cutout Maker 1800
Maintenance Kit
